Vendor: Wellfleet
Module: Wellfleet-NAT-MIB
[Automatically extracted from oidview.com]
wfNatBase OBJECT IDENTIFIER ::= { wfNatGroup 1 }
wfNatBase OBJECT IDENTIFIER ::= { wfNatGroup 1 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.18.3.5.3.2.7.1.1 | wfNatBaseDelete | 1 | 1 | 'This value determines whether NAT is configured' |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.2 | wfNatBaseDisable | 1 | 1 | 'The administrative status of NAT in the router. The value 'enabled' denotes that the NAT Process is active on at least one inte… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.3 | wfNatBaseState | 1 | 1 | 'The state of NAT' |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.4 | wfNatBaseSoloistSlotMask | 1 | 1 | Slot mask for which slots the soloist gate is eligible to run on. The MSBit represents slot 1, the next most significant bit rep… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.5 | wfNatBaseSoloistSlot | 1 | 1 | Slot on which NAT soloist gate is running. Slots can be 1-14. Default is zero. |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.6 | wfNatBaseLogMask | 1 | 1 | A parameter to specify which NAT log messages should be logged. Each bit represents a message as defined below. A 1 in that bit … |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.7 | wfNatBaseMapTimeout | 1 | 1 | This controls whether or not the dynamic mapping table entries are aged out when unused. |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.8 | wfNatBaseMapMaxTimeout | 1 | 1 | The maximum time in seconds before unused NAT mapping table entries are deleted. This timeout or aging does not apply to static m… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.9 | wfNatBaseMapDynMapsCount | 1 | 1 | Number of Dynamic Mappings in the dymanic mapping table |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.10 | wfNatBaseFtpSessionCount | 1 | 1 | Number of FTP sessions detected on this box translated by NAT |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.11 | wfNatBaseNto1TrTotCount | 1 | 1 | Total number of active Nto1 translation counts on the box. |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.12 | wfNatBaseSynchronization | 1 | 1 | The administrative status of NAT Synchronization in the router. The value `enabled' denotes that the NAT Synchronization is activ… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.13 | wfNatBaseSynRouterID | 1 | 1 | This represents the Router Identifier for NAT Synchronization Only. This is used to detect the duplicate TCP connection between p… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.14 | wfNatBaseSynPort | 1 | 1 | This represents the TCP port on which the connection requests from the peers will be accepted. When NAT Synchronization Protocol … |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.15 | wfNatBaseSynKeepAlvInterval | 1 | 1 | Idle session timeout period, in seconds. If an established TCP connection remains inactive for this interval, KEEPALIVE messages… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.16 | wfNatBaseSynKeepAlvTimer | 1 | 1 | KEEPALIVE retransmit timeout period, in seconds. This is the interval at which unacknowledged KEEPALIVE messages will be retrans… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.17 | wfNatBaseSynKeepAlvRetries | 1 | 1 | Number of unacknowledged KEEPALIVE messages retransmitted before the TCP session is terminated. If this count is set to zero, on… |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.18 | wfNatBaseLocalToLocalEnable | 1 | 1 | Allow forwarding of traffic from one local NAT interface to another local NAT interface. |
| 1.3.6.1.4.1.18.3.5.3.2.7.1.19 | wfNatBaseInstallUniPrivAddr | 1 | 1 | This MIB was added in BayRS 14.20 to address a compatibility issue concerning non-DNS NAT translations when upgrading from a pre-… |
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.18.3.5.3.2.7.2 | wfNatAddrRangeTable | 1 | 5 | Table of address ranges that have been designated as the set of external apparent addresses that are to be mapped in place of int… |
| 1.3.6.1.4.1.18.3.5.3.2.7.3 | wfNatLocalAddrRangeTable | 1 | 6 | Table of address ranges that have been designated as the set of local addresses that are to be mapped via NAT. |
| 1.3.6.1.4.1.18.3.5.3.2.7.4 | wfNatStaticMapTable | 1 | 8 | 'This table creates instances of pre-defined NAT mappings.' |
| 1.3.6.1.4.1.18.3.5.3.2.7.5 | wfNatMapTable | 1 | 10 | 'This table defines the current set of address mappings that are in effect.' |
| 1.3.6.1.4.1.18.3.5.3.2.7.6 | wfNatIfTable | 1 | 11 | wfNatIftable |
| 1.3.6.1.4.1.18.3.5.3.2.7.7 | wfNatSynPeerTable | 1 | 9 | The Nat Synchronization Peer table contains configuration and statistical information regarding this router's NAT peers |
| 1.3.6.1.4.1.18.3.5.3.2.7.8 | wfNatAddressRangeTable | 1 | 12 | Table of address ranges. This table was replaced by wfNatSrcAddressFilterTable and wfNatTranslationPoolTable |
| 1.3.6.1.4.1.18.3.5.3.2.7.9 | wfNatStaticMappingTable | 1 | 12 | `This table creates instances of pre-defined NAT translations.' |
| 1.3.6.1.4.1.18.3.5.3.2.7.10 | wfNatMappingTable | 1 | 12 | This table defines the current set of address translations that are in effect. |
| 1.3.6.1.4.1.18.3.5.3.2.7.11 | wfNatIntfTable | 1 | 10 | wfNatIntftable |
| 1.3.6.1.4.1.18.3.5.3.2.7.12 | wfNatSrcAddressFilterTable | 1 | 11 | Table of NAT source address filters. |
| 1.3.6.1.4.1.18.3.5.3.2.7.13 | wfNatTranslationPoolTable | 1 | 7 | Table of address ranges. |