-- -- IRT3020DDA-MIB.my (MIB for DDA-3020) -- v1.0 11/02/2004 -- - Original Issue. IRT3020DDA-MIB DEFINITIONS ::= BEGIN IMPORTS irtProducts FROM IRT-MIB OBJECT-TYPE FROM RFC-1212; -- -- Node definitions -- -- 1.3.6.1.4.1.16557.3.1 irt3020DDA OBJECT IDENTIFIER ::= { irtProducts 1 } -- 1.3.6.1.4.1.16557.3.1.1 irt3020ddaAIS OBJECT-TYPE SYNTAX INTEGER { noAIS(1), inputAIS(2), outputAIS(3), inAndOutAIS(4) } ACCESS read-only STATUS mandatory DESCRIPTION "Alarm Indication Signal status" ::= { irt3020DDA 1 } -- 1.3.6.1.4.1.16557.3.1.2 irt3020ddaTally OBJECT-TYPE SYNTAX INTEGER { inService(1), standby(2) } ACCESS read-write STATUS mandatory DESCRIPTION "Shows if the module is In Service or in Standby" ::= { irt3020DDA 2 } -- 1.3.6.1.4.1.16557.3.1.3 irt3020ddaEnable OBJECT-TYPE SYNTAX INTEGER { enabled(1), inhibited(2) } ACCESS read-only STATUS mandatory DESCRIPTION "The state of the Change-over Enable switch" ::= { irt3020DDA 3 } -- 1.3.6.1.4.1.16557.3.1.4 irt3020ddaLock OBJECT-TYPE SYNTAX INTEGER { locked(1), unLocked(2) } ACCESS read-write STATUS mandatory DESCRIPTION "Shows if the receive PLL is locked" ::= { irt3020DDA 4 } -- 1.3.6.1.4.1.16557.3.1.5 irt3020ddaAisChange OBJECT-TYPE SYNTAX INTEGER { change(1), dontChange(2) } ACCESS read-only STATUS mandatory DESCRIPTION "Indicates the state of the Link which either allows or disallows a change to Standby Status on detection of incoming AIS." ::= { irt3020DDA 5 } -- 1.3.6.1.4.1.16557.3.1.6 irt3020ddaAisOut OBJECT-TYPE SYNTAX INTEGER { allow(1), disallow(2) } ACCESS read-only STATUS mandatory DESCRIPTION "Indicates the state of the Link which either allows or disallows the transmission of AIS when 'Input Loss' is detected." ::= { irt3020DDA 6 } END -- -- IRT3020DDA-MIB.my --