This object is used to specify whether the DSL Line
will automatically train up to the best rate of if
the line rate will be user selectable
Enable - Adjust to the best line rate
Disable - User selectable
Parsed from file hot_msdsl.mib.txt
Company: paradyne
Module: HOTWIRE-MSDSL-INTERFACE-MIB
Vendor: Paradyne
Module: HOTWIRE-MSDSL-INTERFACE-MIB (hot_msdsl.mib)
Type: TABULAR
Access: read-write
Syntax: INTEGER
Automatically extracted from www.mibdepot.com
msdslConfigAutorate OBJECT-TYPE SYNTAX INTEGER { enable(1), disable(2) } ACCESS read-write STATUS mandatory DESCRIPTION "This object is used to specify whether the DSL Line will automatically train up to the best rate of if the line rate will be user selectable Enable - Adjust to the best line rate Disable - User selectable" ::= { msdslNetworkEntry 4 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.1 | msdslConfigNetworkIndex | 0 | 0 | The ifIndex value which uniquely identifies the MSDSL interface to which this entry is applica- ble. |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.2 | msdslConfigMarginThreshold | 0 | 0 | This object is used to set the threshold that determines when a signal to noise margin condition is exceeded. |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.3 | msdslConfigEERThreshold | 0 | 0 | This object is used to set the error rate threshold that determines when an Excessive Error Rate (EER) condition is declared. |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.5 | msdslConfigDSLLineRate | 0 | 0 | An estimate of the interface's current bandwidth in bits per second. Current range is: 144Kbps to 1552Kbps, for DSX1 and 144Kbps … |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.6 | msdslConfigPayLoadRate | 0 | 0 | An estimate of the interface's current bandwidth in bits per second. Current range is: 144Kbps to 2320Kbps. |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.7 | msdslConfigTxAttenuation | 0 | 0 | This object is used to reduce the transmit power of the unit. |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.8 | msdslConfigDSLPeerIPaddr | 0 | 0 | This is used to specify the peer IP address for the remote management link for the DSL loop. |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.9 | msdslConfigDSLCircuitID | 0 | 0 | Used to specify the circuit identifier for the purpose of facilitating troubleshooting. |
| 1.3.6.1.4.1.1795.2.24.2.6.15.1.15.1.1.10 | msdslConfigDSLPortStatus | 0 | 0 | Used to specify port status. |