Number of times the time server has called the ACTS dial-up
service - weather the call was successful or not.
Parsed from file TrueTime.mib.txt
Company: snmpr
Module: TrueTime
Child arc 0 is used to translate between SNMPv1 and SNMPv2 notification parameters as explained in IETF RFC 2576, section 3.
actsNumberOfCalls OBJECT-TYPE SYNTAX Counter (0..4294967295) ACCESS read-only STATUS mandatory DESCRIPTION "Number of times the time server has called the ACTS dial-up service - weather the call was successful or not." ::= { acts 6 }
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.1896.5.6.0 | actsNumberOfCalls | 0 | 0 | None |
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.1896.5.1 | actsGroupValid | 1 | 1 | A test flag indicating if data contained in this SNMP ACTS group is valid or not. This flag equals 1 when ACTS is used as the t… |
1.3.6.1.4.1.1896.5.2 | actsBaudRate | 1 | 1 | Indicates the baud rate setting for the ACTS modem. The ACTS dial-up service accepts 300 or 1200 baud. Note: this is a rare ca… |
1.3.6.1.4.1.1896.5.3 | actsFailRedial | 1 | 1 | When the dial-up session fails to connect this is the time in seconds to wait to try again. |
1.3.6.1.4.1.1896.5.4 | actsMaxCallPeriod | 1 | 1 | This is the maximum time in hours the ACTS unit will wait between successful calls to the ACTS service. |
1.3.6.1.4.1.1896.5.5 | actsPhoneNum | 1 | 1 | This is the phone number of the ACTS dial-up service, including any prefixes needed to reach an outside line or international di… |
1.3.6.1.4.1.1896.5.7 | actsGoodCalls | 1 | 1 | Number of times the time server called the ACTS dial-up service and successfully received the time. |
1.3.6.1.4.1.1896.5.8 | actsBadCalls | 1 | 1 | Number of times the time server called the ACTS dial-up service and something was not right. This variable is the sum total of … |
1.3.6.1.4.1.1896.5.9 | actsFailedInit | 1 | 1 | Time server's internal modem failed to initialize. If this is excessive, it may indicate a time server hardware failure. |
1.3.6.1.4.1.1896.5.10 | actsNoDialTone | 1 | 1 | Time server's internal modem found no dial tone. This may be caused by a broken phone line to the time server. |
1.3.6.1.4.1.1896.5.11 | actsNoCarrier | 1 | 1 | Time server's internal modem found no carrier. No modem was found at the other end and maybe the phone number for ACTS is wrong. |
1.3.6.1.4.1.1896.5.12 | actsBusyLine | 1 | 1 | Time server's internal modem found ACTS line busy. |
1.3.6.1.4.1.1896.5.13 | actsNoAnswer | 1 | 1 | The remote ACTS mode did not answer the call. |
1.3.6.1.4.1.1896.5.14 | actsBadReply | 1 | 1 | The syntax of the reply from remote modem was incorrect, possibly due to line noise. |
1.3.6.1.4.1.1896.5.15 | actsNoOnTimeMark | 1 | 1 | The reply from remote modem had no on time mark, possibly due to line noise. |