Port ThrottleBack mode. If set to
default(1) value from
defaultThrottleBackMode is used.
Parsed from file SCA_ESWT.MIB.txt
Company: None
Module: ETH-SWITCH-MIB
portIfthrottleBack
View at oid-info.com
Port ThrottleBack mode. If set to
default(1) value from
defaultThrottleBackMode is used.
Parsed from file ETH-SWITCH-MIB.mib
Module: ETH-SWITCH-MIB
portIfThrottleBack OBJECT-TYPE SYNTAX INTEGER { default(1), enable(2), disable(3), notAvailable(99) } ACCESS read-write STATUS mandatory DESCRIPTION "Port ThrottleBack mode. If set to default(1) value from defaultThrottleBackMode is used." ::= { portIfEntry 6 }
Vendor: Cray Communications A/S
Module: ETH-SWITCH-MIB
[Automatically extracted from oidview.com]
portIfThrottleBack OBJECT-TYPE SYNTAX INTEGER { default(1), enable(2), disable(3), notAvailable(99) } ACCESS read-write STATUS mandatory DESCRIPTION "Port ThrottleBack mode. If set to default(1) value from defaultThrottleBackMode is used." ::= { portIfEntry 6 }
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.208.39.3.3.1.1 | portIfIndex | 0 | 0 | An index value that uniquely identifies an interface. The interface identified by a particular value of this index is the same int… |
1.3.6.1.4.1.208.39.3.3.1.2 | portIfDescr | 0 | 0 | User configurable description of the port. |
1.3.6.1.4.1.208.39.3.3.1.3 | portIfLocation | 0 | 0 | User configurable location of the port. |
1.3.6.1.4.1.208.39.3.3.1.4 | portIfSwitchMode | 0 | 0 | Port Switch mode. If set to default(1) value from defaultSwitchMode is used. |
1.3.6.1.4.1.208.39.3.3.1.5 | portIfDuplex | 0 | 0 | Port Duplex mode. For ports in auto mode the mode may change automatically between autoDetect(1), autoDetectedHalf(3) and autoDete… |
1.3.6.1.4.1.208.39.3.3.1.7 | portIfType | 0 | 0 | portIftype |
1.3.6.1.4.1.208.39.3.3.1.8 | portIfDuplexSupported | 0 | 0 | The duplex mode supported for a port. |
1.3.6.1.4.1.208.39.3.3.1.9 | portIfSpeedSupported | 0 | 0 | The speed supported for a port. |
1.3.6.1.4.1.208.39.3.3.1.10 | portIfSpeedAndDuplex | 0 | 0 | This object is used to configure the speed and duplex mode for a port. Byte 1: negotiation manual(0) autoDisable(1) autoAlternative(… |