The length of time to wait before dropping a VNIP
peer from the database and attempting tp reestablish
communications by issuing the VNIP Hello message. If
this timer expires then the entire topology database
is reset. The Inactivity timers of any unit participating
in a VNIP topology must be greater than the highest Keep
Alive timer in the topology.
(5- 86400) VNIP Hello frequency (in seconds)
Parsed from file TFRAP.MIB.txt
Company: None
Module: TFRAP-MIB
The length of time to wait before dropping a VNIP
peer from the database and attempting tp reestablish
communications by issuing the VNIP Hello message. If
this timer expires then the entire topology database
is reset. The Inactivity timers of any unit participating
in a VNIP topology must be greater than the highest Keep
Alive timer in the topology.
(5- 86400) VNIP Hello frequency (in seconds)
Parsed from file TFRAP-MIB.mib
Module: TFRAP-MIB
Vendor: Sync Research, Inc.
Module: TFRAP-MIB
[Automatically extracted from oidview.com]
tfrapCfgVnipInactivityTimer OBJECT-TYPE SYNTAX INTEGER (5..86400) ACCESS read-write STATUS mandatory DESCRIPTION "The length of time to wait before dropping a VNIP peer from the database and attempting tp reestablish communications by issuing the VNIP Hello message. If this timer expires then the entire topology database is reset. The Inactivity timers of any unit participating in a VNIP topology must be greater than the highest Keep Alive timer in the topology. (5- 86400) VNIP Hello frequency (in seconds)" ::= { tfrapCfgVnipTable 4 }
tfrapCfgVnipInactivityTimer OBJECT-TYPE SYNTAX INTEGER (5..86400) ACCESS read-write STATUS mandatory DESCRIPTION "The length of time to wait before dropping a VNIP peer from the database and attempting tp reestablish communications by issuing the VNIP Hello message. If this timer expires then the entire topology database is reset. The Inactivity timers of any unit participating in a VNIP topology must be greater than the highest Keep Alive timer in the topology. (5- 86400) VNIP Hello frequency (in seconds)" ::= { tfrapCfgVnipTable 4 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.485.5.2.6.4.0 | tfrapCfgVnipInactivityTimer | 0 | 0 | None |
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.485.5.2.6.1 | tfrapCfgVnipMode | 1 | 1 | This setting configures the unit for VNIP topology support on a per-interface basis. Establishing a VNIP topology is a fundamenta… |
| 1.3.6.1.4.1.485.5.2.6.2 | tfrapCfgVnipInitTimer | 1 | 1 | VNIP peer to peer communications are initiated following the detection of a VNIP Hello message. The unit will periodically issue … |
| 1.3.6.1.4.1.485.5.2.6.3 | tfrapCfgVnipKeepAliveTimer | 1 | 1 | This is the frequency that topology reports are issued out any interface that has VNIP enabled. Once a Hello exchange occurs, the… |
| 1.3.6.1.4.1.485.5.2.6.5 | tfrapCfgVnipTransitDelayFrequency | 1 | 1 | Transit Delay measurements may be enabled between any DLCI peers that have been logged through the topology protocol. Delay messa… |
| 1.3.6.1.4.1.485.5.2.6.20 | tfrapCfgTransitDelayTable | 1 | 6 | The table defining the transit delay measurement profile for each of the learned VNIP peers. As peers are located and logged into… |
| 1.3.6.1.4.1.485.5.2.6.21 | tfrapCfgTDDeleteTable | 1 | 3 | The table allows the user to disable transit delay measurements for a specific DLCI on a particular interface. |
| 1.3.6.1.4.1.485.5.2.6.22 | tfrapCfgTransitDelayTableClear | 1 | 1 | The tfrapCfgTransitDelayTable is cleared. (1) clear the table |