A station will join a new AP only if the AP transmits with
an RSSI quality above the value which is defined by this parameter.
Available ONLY in stations.
In AP's, this is the threshold for sending Bad WLAN Conditions traps.
If a station associated with the AP is heard at an RSII level below
this threshold, a Bad WLAN Conditions trap is sent by the AP.
Parsed from file BREEZECOM-MIB.mib
Module: BREEZECOM-MIB
Vendor: Lannair Ltd.
Module: BREEZECOM-MIB
[Automatically extracted from oidview.com]
brzJoinDecisionRSSIThreshold OBJECT-TYPE SYNTAX INTEGER ACCESS read-write STATUS mandatory DESCRIPTION "A station will join a new AP only if the AP transmits with an RSSI quality above the value which is defined by this parameter. Available ONLY in stations. In AP's, this is the threshold for sending Bad WLAN Conditions traps. If a station associated with the AP is heard at an RSII level below this threshold, a Bad WLAN Conditions trap is sent by the AP." ::= { brzRoamParams 4 }
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.710.3.2.3.4.1 | brzRoamDecisionWin | 0 | 0 | This parameter defines a minimum number of RSSI samples which is required to make a decision about the current WLAN channel quali… |
1.3.6.1.4.1.710.3.2.3.4.2 | brzRoamDecisionNumerator | 0 | 0 | This parameter defines a maximum number of RSSI samples that is allowed to be below brzRoamDecisionRSSIThreshold, among a number … |
1.3.6.1.4.1.710.3.2.3.4.3 | brzRoamDecisionRSSIThreshold | 0 | 0 | If an RSSI sample is bellow the value which is defined by this parameter the sample is considered as bad. Available ONLY in stati… |
1.3.6.1.4.1.710.3.2.3.4.5 | brzNeighboringBeacons | 0 | 0 | This parameters defines once in how many dwell times the AP will send a neighboring beacon. Available ONLY in AP's. |
1.3.6.1.4.1.710.3.2.3.4.6 | brzNumberOfProbeResponses | 0 | 0 | If a number of good RSSI samples coming from a neighbor is greater than or equal to this parameter the neighbor might be selecte… |
1.3.6.1.4.1.710.3.2.3.4.7 | brzNumberOfBeaconsForDisconnect | 0 | 0 | This parameter defines a maximum number of consecutive not arrived Beacons that is allowed before a disconnect decision. Availabl… |
1.3.6.1.4.1.710.3.2.3.4.8 | brzMaxNumberOfScanning | 0 | 0 | This parameter defines a maximum number of scanning Attempts to perform before system reset. Zero is value for non reset. Availab… |
1.3.6.1.4.1.710.3.2.3.4.9 | brzNeighboringBeaconRate | 0 | 0 | This parameter defines the Neighboring Beacon Rate in dwells. Zero is value for non Neighboring Beacons. Available ONLY in AP's. |