| 1.3.6.1.2.1.10.238.1.5.1.2.1.1 |
adsl2LConfProfProfileName | 0 | 0 |
This object identifies a row in this table. |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.2 |
adsl2LConfProfScMaskDs | 0 | 0 |
Sub-carriers mask. A bitmap of 512 bits that allows masking up to 512 downstream sub-carriers, depending on NSCds. If bit i (0 … |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.3 |
adsl2LConfProfScMaskUs | 0 | 0 |
Sub-carriers mask. A bitmap of 64 bits that allows masking up to 64 downstream sub-carriers, depending on NSCds. If bit i (0 <=… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.4 |
adsl2LConfProfRfiBandsDs | 0 | 0 |
The subset of downstream PSD mask breakpoints that shall be used to notch an RFI band. The specific interpolation around these … |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.5 |
adsl2LConfProfRaModeDs | 0 | 0 |
The mode of operation of a rate-adaptive ATU-C in the transmit direction. The parameter can take three values: manual(1), raInit(… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.6 |
adsl2LConfProfRaModeUs | 0 | 0 |
The mode of operation of a rate-adaptive ATU-R in the transmit direction. The parameter can take three values: manual(1), raInit(… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.7 |
adsl2LConfProfRaUsNrmDs | 0 | 0 |
The Downstream Up-Shift Noise Margin value, to be used when adsl2LConfProfRaModeDs is set to dynamicRa. If the downstream noise … |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.8 |
adsl2LConfProfRaUsNrmUs | 0 | 0 |
The Upstream Up-Shift Noise Margin value, to be used when adsl2LConfProfRaModeUs is set to dynamicRa. If the upstream noise marg… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.9 |
adsl2LConfProfRaUsTimeDs | 0 | 0 |
The Downstream Up-Shift Time Interval, to be used when adsl2LConfProfRaModeDs is set to dynamicRa. The interval of time that the… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.10 |
adsl2LConfProfRaUsTimeUs | 0 | 0 |
The Upstream Up-Shift Time Interval, to be used when adsl2LConfProfRaModeUs is set to dynamicRa. The interval of time the upstre… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.11 |
adsl2LConfProfRaDsNrmsDs | 0 | 0 |
The Downstream Down-Shift Noise Margin value, to be used when adsl2LConfProfRaModeDs is set to dynamicRa. If the downstream nois… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.12 |
adsl2LConfProfRaDsNrmsUs | 0 | 0 |
The Upstream Down-Shift Noise Margin value, to be used when adsl2LConfProfRaModeUs is set to dynamicRa. If the upstream noise ma… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.13 |
adsl2LConfProfRaDsTimeDs | 0 | 0 |
The Downstream Down-Shift Time Interval, to be used when adsl2LConfProfRaModeDs is set to dynamicRa. The interval of time the do… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.14 |
adsl2LConfProfRaDsTimeUs | 0 | 0 |
The Upstream Down-Shift Time Interval, to be used when adsl2LConfProfRaModeUs is set to dynamicRa. The interval of time the upst… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.15 |
adsl2LConfProfTargetSnrmDs | 0 | 0 |
The minimum Noise Margin the ATU-R receiver shall achieve, relative to the BER requirement for each of the downstream bearer chan… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.16 |
adsl2LConfProfTargetSnrmUs | 0 | 0 |
The minimum Noise Margin the ATU-C receiver shall achieve, relative to the BER requirement for each of the upstream bearer channe… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.17 |
adsl2LConfProfMaxSnrmDs | 0 | 0 |
The maximum Noise Margin the ATU-R receiver shall try to sustain. If the Noise Margin is above this level, the ATU-R shall reque… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.18 |
adsl2LConfProfMaxSnrmUs | 0 | 0 |
The maximum Noise Margin the ATU-C receiver shall try to sustain. If the Noise Margin is above this level, the ATU-C shall reque… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.19 |
adsl2LConfProfMinSnrmDs | 0 | 0 |
The minimum Noise Margin the ATU-R receiver shall tolerate. If the noise margin falls below this level, the ATU-R shall request t… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.20 |
adsl2LConfProfMinSnrmUs | 0 | 0 |
The minimum Noise Margin the ATU-C receiver shall tolerate. If the noise margin falls below this level, the ATU-C shall request t… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.21 |
adsl2LConfProfMsgMinUs | 0 | 0 |
Minimum Overhead Rate Upstream. Defines the minimum rate of the message-based overhead that shall be maintained by the ATU in up… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.22 |
adsl2LConfProfMsgMinDs | 0 | 0 |
Minimum Overhead Rate Downstream. Defines the minimum rate of the message-based overhead that shall be maintained by the ATU in … |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.23 |
adsl2LConfProfAtuTransSysEna | 0 | 0 |
ATU Transmission System Enabling (ATSE). A list of the different coding types enabled in this profile. It is coded in a bit-map… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.24 |
adsl2LConfProfPmMode | 0 | 0 |
Power management state Enabling. Defines the power states the ATU-C or ATU-R may autonomously transition to on this line. The va… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.25 |
adsl2LConfProfL0Time | 0 | 0 |
This minimum time (in seconds) between an Exit from the L2 state and the next Entry into the L2 state. It ranges from 0 to 255 s… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.26 |
adsl2LConfProfL2Time | 0 | 0 |
This minimum time (in seconds) between an Entry into the L2 state and the first Power Trim in the L2 state and between two consec… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.27 |
adsl2LConfProfL2Atpr | 0 | 0 |
The maximum aggregate transmit power reduction (in dB) that can be performed at transition of L0 to L2 state or through a single … |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.28 |
adsl2LConfProfL2Atprt | 0 | 0 |
The total maximum aggregate transmit power reduction (in dB) that can be performed in an L2 state. This is the sum of all reduct… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.29 |
adsl2LConfProfRowStatus | 0 | 0 |
This object is used to create a new row or to modify or delete an existing row in this table.
A profile is activated by setting t… |
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65535 |
adsl2LConfProfTrellisMode | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65536 |
adsl2LConfProfBitSwapDs | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65537 |
adsl2LConfProfBitSwapUs | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65538 |
adsl2LConfProfDpboEPsd | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65539 |
adsl2LConfProfDpboEsEL | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65540 |
adsl2LConfProfDpboEsCableModelA | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65541 |
adsl2LConfProfDpboEsCableModelB | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65542 |
adsl2LConfProfDpboEsCableModelC | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65544 |
adsl2LConfProfDpboFMin | 0 | 0 |
|
| 1.3.6.1.2.1.10.238.1.5.1.2.1.65545 |
adsl2LConfProfDpboFMax | 0 | 0 |
|