Status in source: current.
Names: apexSesContConfTable
Technical details
{
"smi_kind": "OBJECT-TYPE",
"definition": [
"apexSesContConfTable",
"OBJECT-TYPE",
"SYNTAX",
"SEQUENCE",
"OF",
"ApexSesContConfEntry",
"MAX-ACCESS",
"not-accessible",
"STATUS",
"current",
"DESCRIPTION",
"\"This is a table of Session Control configuration parameters for each output transport stream. This table defines the primary and secondary Gigabit Ethernet interfaces for each output stream in Session Control operating mode. The primary and secondary interfaces cannot be changed for an output stream when there are active Session Control mappings. All Session Control mappings on an output stream must be removed prior to changing the primary or secondary interface settings. Once written, the change to this table will only take immediate effect after apexSesContConfTableApplyChange is set to 'apply'. In order for the change to persist through subsequent reboots or power cycles, the change must be saved via the apexSaveConfig parameter. @Config(config=yes, reboot=no) @Commit(param=apexSesContConfTableApplyChange, value=2) @Save(apexSaveConfig, value=2) @File(sdv.ini, type='ini') \"",
"::=",
"{",
"apexSessionControlConfig",
"2",
"}"
],
"syntax_tree": [
[
"conceptualTable",
[
"row",
"ApexSesContConfEntry"
]
],
null,
[
"MaxAccessPart",
"not-accessible"
],
[
"Status",
"current"
],
[
"DESCRIPTION",
"This is a table of Session Control configuration parameters for each output transport stream. This table defines the primary and secondary Gigabit Ethernet interfaces for each output stream in Session Control operating mode. The primary and secondary interfaces cannot be changed for an output stream when there are active Session Control mappings. All Session Control mappings on an output stream must be removed prior to changing the primary or secondary interface settings. Once written, the change to this table will only take immediate effect after apexSesContConfTableApplyChange is set to 'apply'. In order for the change to persist through subsequent reboots or power cycles, the change must be saved via the apexSaveConfig parameter. @Config(config=yes, reboot=no) @Commit(param=apexSesContConfTableApplyChange, value=2) @Save(apexSaveConfig, value=2) @File(sdv.ini, type='ini')"
],
null,
null,
null,
null
]
}