Status in source: current.
Technical details
{
"smi_kind": "OBJECT-TYPE",
"definition": [
"apType",
"OBJECT-TYPE",
"SYNTAX",
"INTEGER",
"{",
"standard",
"(",
"0",
")",
",",
"remote",
"(",
"1",
")",
"}",
"MAX-ACCESS",
"read-write",
"STATUS",
"current",
"DESCRIPTION",
"\"In standard mode, all possible sync sources will be made availble and usedfor autoSync operation. In remote mode, sync over power port will not be available as a sync source. Remote Device mode is where the AP or BHM timing port is connected to an SM or BHS timing port via a sync cable. In this mode, GPS data is unavailable and sync over power port shouldn't be used. If sync over power is desired, and a CMM or other sync over power device is in use, then select standard mode. On 450b PTP BHM, this mode cannot be enabled while Sync Aux Port Config is set to Output or Alignment Tone, because these signals share a physical pin with the sync input signal. On MicroPoP, this feature does not have hardware support.\"",
"::=",
"{",
"whispBoxConfig",
"216",
"}"
],
"syntax_tree": [
[
"SimpleSyntax",
"INTEGER",
[
"enumSpec",
[
[
"standard",
0
],
[
"remote",
1
]
]
]
],
null,
[
"MaxAccessPart",
"read-write"
],
[
"Status",
"current"
],
[
"DESCRIPTION",
"In standard mode, all possible sync sources will be made availble and usedfor autoSync operation. In remote mode, sync over power port will not be available as a sync source. Remote Device mode is where the AP or BHM timing port is connected to an SM or BHS timing port via a sync cable. In this mode, GPS data is unavailable and sync over power port shouldn't be used. If sync over power is desired, and a CMM or other sync over power device is in use, then select standard mode. On 450b PTP BHM, this mode cannot be enabled while Sync Aux Port Config is set to Output or Alignment Tone, because these signals share a physical pin with the sync input signal. On MicroPoP, this feature does not have hardware support."
],
null,
null,
null,
null
]
}