sCellEventTrap_4_3 — HPE networking MIB copies (LibreNMS/Observium Community), MIBdepot
Severity: Critical -- failure or failure imminent. An unexpected event occurred while a termination event was being processed. The value contained in the uei.type field describes the event as follows: <UL><LI>0 = Unrecognized Unexpected Event code. <LI>1 = Power failure before initialization could complete. <LI>2 = Recursive termination before initialization could complete. <LI>3 = Terminated during the first part post-termination preparation. <LI>4 = Terminated during the load of the G3 Glue registers. <LI>5 = Terminated during the second part post-termination preparation. <LI>6 = Terminated during event report block load. <LI>7 = Terminated during initialization of all hardware components and software data structures in preparation for restart. <LI>8 = Terminated during execution of an unrecognized post-termination operation (premature). <LI>9 = Power failure during execution of a post-termination operation. <LI>A = No good entries found in Termination Event Array. (Note that this condition is expected following the first boot of a newly manufactured HSV110 controller. In that case this event can be safely ignored; no action is necessary.) <LI>B = The EDC of one or more Termination Event Array entries is bad. <LI>C = Termination Event Array entry control block revision is different. <LI>D = Termination Event Array entry information block revision is different. <LI>E = Termination Event Array entry up time value is greater than the system's up time value. <LI>F = Termination Event Array entry up time value is less than the previous entry's up time value. <LI>10= Termination Event Array entry sequence number value is less than the previous entry's sequence number value. <LI>11= Detected an unrecognized dump/restart control code. <LI>12= Failed to terminate the entity dump loop. <LI>13= Unexpected dump entity size. <LI>14= Unexpected Event Log Packet processing stage code. <LI>15= Number of Termination Parameters supplied not equal to maximum allowed as required. </UL><P> The post-termination operation being performed at the time the unexpected event occurred is contained in the uei.pto field. Note: The lteihd and lter fields may not describe the event that caused the HSV110 controller to terminate operation depending on how far termination processing got before the unexpected event occurred.