Description 1
A port may reside within multiple VLANs only if
the object vlanAllowMembershipOverlap has been set
to enabled.
This object cannot be used to configure VLAN
membership. The table vlanMemberTable is used
for that purpose.
Each octet within the value of this object specifies a
set of eight ports, with the first octet specifying ports
1 through 8, the second octet specifying ports 9
through 16, etc. Within each octet, the most
significant bit represents the lowest numbered
port, and the least significant bit represents the
highest numbered port. Thus, each port of the
VLAN is represented by a single bit within the
value of this object. If that bit has a value of
'1' then that port is included in the set of
ports; the port is not included if its bit has a
value of '0'.
Initially, a single VLAN with all ports as its
members is defined.
This object is not supported by switches operating
with firmware version greater than or equal to 6.00
Sources for this description
Circitor
Parsed from STAND-ALONE-ETHERNET-SWITCH-MIB.mib · STAND-ALONE-ETHERNET-SWITCH-MIB
Source file: Download ESSWITCH-MIB.my · Publisher's file
Vendor MIB copy from the Netdisco archive.
Related source files and packages:
Source file: Download STAND-ALONE-ETHERNET-SWITCH-MIB · Publisher's file
Vendor MIB copy from the Observium Community archive. Cisco support.
Related source files and packages:
Source file: Download STAND-ALONE-ETHERNET-SWITCH-MIB.mib
Cisco SMIv1
Source file: Download ESSWITCH-MIB.my · Publisher's file