Status in source: current.
Technical details
{
"smi_kind": "OBJECT-TYPE",
"definition": [
"nbsSffDiagsSoftRSSelect",
"OBJECT-TYPE",
"SYNTAX",
"INTEGER",
"{",
"off",
"(",
"1",
")",
",",
"on",
"(",
"2",
")",
"}",
"MAX-ACCESS",
"read-only",
"STATUS",
"current",
"DESCRIPTION",
"\"Read/write bit that allows software Tx rate control. Writing 1 selects full speed Tx operation. This bit is OR d with the hard RS(1) pin value.See Table 3.11 for timing requirements. Default at power up is logic zero/low. If Soft RS(1) is not implemented, the transceiver ignores the value of this bit. Note: Specific transceiver behaviors of this bit are identified in Table 3.6a and referenced documents. See Table 3.17, byte 110, bit 3 for Soft RS(0) Select.\"",
"REFERENCE",
"\"Diagnostic Monitoring Interface for Optical Transceivers, SFF-8472 Rev 10.3 Table 3.18a of A2h\"",
"::=",
"{",
"nbsSffDiagsEntry",
"63",
"}"
],
"syntax_tree": [
[
"SimpleSyntax",
"INTEGER",
[
"enumSpec",
[
[
"off",
1
],
[
"on",
2
]
]
]
],
null,
[
"MaxAccessPart",
"read-only"
],
[
"Status",
"current"
],
[
"DESCRIPTION",
"Read/write bit that allows software Tx rate control. Writing 1 selects full speed Tx operation. This bit is OR d with the hard RS(1) pin value.See Table 3.11 for timing requirements. Default at power up is logic zero/low. If Soft RS(1) is not implemented, the transceiver ignores the value of this bit. Note: Specific transceiver behaviors of this bit are identified in Table 3.6a and referenced documents. See Table 3.17, byte 110, bit 3 for Soft RS(0) Select."
],
[
"REFERENCE",
"Diagnostic Monitoring Interface for Optical Transceivers, SFF-8472 Rev 10.3 Table 3.18a of A2h"
],
null,
null,
null
]
}