Status in source: current.
Names: tmnxPtpVRtrIfAdminState
Technical details
{
"smi_kind": "OBJECT-TYPE",
"definition": [
"tmnxPtpVRtrIfAdminState",
"OBJECT-TYPE",
"SYNTAX",
"TmnxAdminState",
"MAX-ACCESS",
"read-create",
"STATUS",
"current",
"DESCRIPTION",
"\"The value of tmnxPtpVRtrIfAdminState specifies the administrative state of the PTP hardware assist configuration of the interface. If the value is 'inService(2)', the timestamp point for PTP event packets is configured to be the physical layer. This corresponds to timestamp point 'A' in IEEE 1588-2008, Figure 14. If the value is 'outOfService(3)', the timestamp point for PTP event packets is configured to be the operating system kernel. This corresponds to timestamp point 'B' in IEEE 1588-2008, Figure 14. The value may only be configured to 'inService(2)' if all of the following are true: 1. An IPv4 address is configured against the interface. 2. An Ethernet physical port or link aggregation group (or VLAN tag on an Ethernet physical port or link aggregation group) has been associated with the interface. 3. The Ethernet port or all member ports of the link aggregation group associated with the interface must not be configured for WAN mode. In other words, the tmnxPortEtherXGigMode attribute for the port must be either 'notApplicable' or 'lan'. 4. The MDA associated with the interface has synchronous Ethernet enabled. In other words, the tmnxMDASynchronousEthernet attribute for the MDA must be 'enabled'. 5. The port or every member port of the link aggregation group associated with the interface is on an IOM that supports the hardware assist configuration. 6. The port or every member port of the link aggregation group associated with the interface supports the hardware assist configuration. 7. The firmware currently in use by the active CPM support the hardware assist configuration. 8. The firmware currently in use by the IOM card supports the hardware assist configuration. After an upgrade from an older release, the IOM may continue using older firmware. A hard reset of the IOM is then needed to bring the IOM firmware up to date. 9. The firmware currently in use by the MDA supports the hardware assist configuration. After an upgrade from an older release, the MDA may continue using older firmware. A hard reset of the MDA or IOM is then needed to bring the MDA firmware up to date. If the physical port bound to the interface is removed, tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'. If the IPv4 address assigned to the interface is removed, tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'.\"",
"REFERENCE",
"\"IEEE 1588-2008, section 6.5.5.\"",
"::=",
"{",
"tmnxPtpVRtrIfEntry",
"1",
"}"
],
"syntax_tree": [
[
"row",
"TmnxAdminState"
],
null,
[
"MaxAccessPart",
"read-create"
],
[
"Status",
"current"
],
[
"DESCRIPTION",
"The value of tmnxPtpVRtrIfAdminState specifies the administrative state of the PTP hardware assist configuration of the interface. If the value is 'inService(2)', the timestamp point for PTP event packets is configured to be the physical layer. This corresponds to timestamp point 'A' in IEEE 1588-2008, Figure 14. If the value is 'outOfService(3)', the timestamp point for PTP event packets is configured to be the operating system kernel. This corresponds to timestamp point 'B' in IEEE 1588-2008, Figure 14. The value may only be configured to 'inService(2)' if all of the following are true: 1. An IPv4 address is configured against the interface. 2. An Ethernet physical port or link aggregation group (or VLAN tag on an Ethernet physical port or link aggregation group) has been associated with the interface. 3. The Ethernet port or all member ports of the link aggregation group associated with the interface must not be configured for WAN mode. In other words, the tmnxPortEtherXGigMode attribute for the port must be either 'notApplicable' or 'lan'. 4. The MDA associated with the interface has synchronous Ethernet enabled. In other words, the tmnxMDASynchronousEthernet attribute for the MDA must be 'enabled'. 5. The port or every member port of the link aggregation group associated with the interface is on an IOM that supports the hardware assist configuration. 6. The port or every member port of the link aggregation group associated with the interface supports the hardware assist configuration. 7. The firmware currently in use by the active CPM support the hardware assist configuration. 8. The firmware currently in use by the IOM card supports the hardware assist configuration. After an upgrade from an older release, the IOM may continue using older firmware. A hard reset of the IOM is then needed to bring the IOM firmware up to date. 9. The firmware currently in use by the MDA supports the hardware assist configuration. After an upgrade from an older release, the MDA may continue using older firmware. A hard reset of the MDA or IOM is then needed to bring the MDA firmware up to date. If the physical port bound to the interface is removed, tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'. If the IPv4 address assigned to the interface is removed, tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'."
],
[
"REFERENCE",
"IEEE 1588-2008, section 6.5.5."
],
null,
null,
null
]
}
- Nokia networking MIB copies (LibreNMS/Observium Community)
· Publisher's source file: Source package: observium-community-latest.tar.gz
Vendor MIB copy from the Observium Community archive.
Nokia support.
Module: TIMETRA-PTP-MIB
See published definition above
Module imports
{'SNMPv2-TC': ['DateAndTime', 'MacAddress', 'RowPointer', 'RowStatus', 'TEXTUAL-CONVENTION', 'TimeStamp', 'TruthValue'], 'SNMPv2-SMI': ['Counter32', 'Integer32', 'MODULE-IDENTITY', 'NOTIFICATION-TYPE', 'OBJECT-TYPE', 'Unsigned32'], 'SNMPv2-CONF': ['MODULE-COMPLIANCE', 'NOTIFICATION-GROUP', 'OBJECT-GROUP'], 'TIMETRA-TC-MIB': ['TItemDescription', 'TmnxAdminState', 'TmnxEncapVal', 'TmnxOperState', 'TmnxPortID'], 'INET-ADDRESS-MIB': ['InetAddress', 'InetAddressType'], 'TIMETRA-PORT-MIB': ['TmnxPortEncapType', 'tmnxPortPortID'], 'TIMETRA-VRTR-MIB': ['vRtrID', 'vRtrIfEntry'], 'TIMETRA-GLOBAL-MIB': ['timetraSRMIBModules', 'tmnxSRConfs', 'tmnxSRNotifyPrefix', 'tmnxSRObjs'], 'TIMETRA-CHASSIS-MIB': ['tmnxChassisIndex', 'tmnxChassisNotifyChassisId', 'tmnxChassisNotifyHwIndex', 'tmnxCpmCardEntry', 'tmnxCpmCardOscillatorType']}
Related source files and packages:
- Netdisco MIB archive copies
· Publisher's source file: timetra-ptp-mib.mib
Vendor MIB copy from the Netdisco archive.
Module: TIMETRA-PTP-MIB
See published definition above
Module imports
{'SNMPv2-TC': ['TEXTUAL-CONVENTION', 'RowStatus', 'TimeStamp', 'TruthValue', 'RowPointer', 'DateAndTime', 'MacAddress'], 'SNMPv2-SMI': ['MODULE-IDENTITY', 'OBJECT-TYPE', 'NOTIFICATION-TYPE', 'Unsigned32', 'Counter32', 'Integer32'], 'SNMPv2-CONF': ['MODULE-COMPLIANCE', 'OBJECT-GROUP', 'NOTIFICATION-GROUP'], 'TIMETRA-TC-MIB': ['TmnxAdminState', 'TmnxOperState', 'TItemDescription', 'TmnxPortID', 'TmnxEncapVal'], 'INET-ADDRESS-MIB': ['InetAddressType', 'InetAddress'], 'TIMETRA-PORT-MIB': ['TmnxPortEncapType', 'tmnxPortPortID'], 'TIMETRA-VRTR-MIB': ['vRtrID', 'vRtrIfEntry'], 'TIMETRA-GLOBAL-MIB': ['timetraSRMIBModules', 'tmnxSRObjs', 'tmnxSRNotifyPrefix', 'tmnxSRConfs'], 'TIMETRA-CHASSIS-MIB': ['tmnxChassisIndex', 'tmnxChassisNotifyChassisId', 'tmnxChassisNotifyHwIndex', 'tmnxCpmCardEntry', 'tmnxCpmCardOscillatorType']}
Related source files and packages: