Status in source: current.
Names: aluRS232MonClockDeviationClear
Technical details
{
"smi_kind": "OBJECT-TYPE",
"definition": [
"aluRS232MonClockDeviationClear",
"OBJECT-TYPE",
"SYNTAX",
"Unsigned32",
"(",
"0",
"|",
"10",
".",
".",
"100",
")",
"UNITS",
[
"literal",
"227365636f6e647322"
],
"MAX-ACCESS",
"read-create",
"STATUS",
"current",
"DESCRIPTION",
"\"The value of the object aluRS232MonClockDeviationClear specifies the amount of time to debounce no clock deviation before de-asserting the port fault condition, 'monClockDeviation'. No clock deviation is detected when the external clock does not exceed a +/- 6% deviation from the internal interface rate clock. The special value 0 means clock deviation monitoring is disabled (ie. detection off and any concurrent assertion will be cleared immediately). While this object is 0, aluRS232MonClockDeviationRaise must also be 0. Non-zero values must be specified in increments of 10. Non-zero values not supported on SAR-H and SAR-Hc systems. Non-zero values not supported on sdiv1 and sdiv2. Non-zero values not allowed while aluRS232DeviceMode is asynchronous. \"",
"DEFVAL",
"{",
"0",
"}",
"::=",
"{",
"aluRS232Entry",
"38",
"}"
],
"syntax_tree": [
[
"ApplicationSyntax",
"Unsigned32",
[
"integerSubType",
[
[
0
],
[
10,
100
]
]
]
],
[
"UNITS",
"seconds"
],
[
"MaxAccessPart",
"read-create"
],
[
"Status",
"current"
],
[
"DESCRIPTION",
"The value of the object aluRS232MonClockDeviationClear specifies the amount of time to debounce no clock deviation before de-asserting the port fault condition, 'monClockDeviation'. No clock deviation is detected when the external clock does not exceed a +/- 6% deviation from the internal interface rate clock. The special value 0 means clock deviation monitoring is disabled (ie. detection off and any concurrent assertion will be cleared immediately). While this object is 0, aluRS232MonClockDeviationRaise must also be 0. Non-zero values must be specified in increments of 10. Non-zero values not supported on SAR-H and SAR-Hc systems. Non-zero values not supported on sdiv1 and sdiv2. Non-zero values not allowed while aluRS232DeviceMode is asynchronous."
],
null,
null,
null,
[
"DEFVAL",
0
]
]
}