Specifies the token bucket size in bytes
for this parameter set. The value is calculated
from the byte following the MAC header HCS to
the end of the CRC. This object is applied in
conjunction with docsQosParamSetMaxTrafficRate to
calculate maximum sustained traffic rate.
If the referenced parameter is not present in the
corresponding DOCSIS QOS Parameter Set, the default
value of this object for scheduling types
bestEffort (2), nonRealTimePollingService(3),
and realTimePollingService(4) is 1522.
If this parameter is not applicable, it is reported
as 0.
Specifies the token bucket size in bytes
for this parameter set. The value is calculated
from the byte following the MAC header HCS to
the end of the CRC. This object is applied in
conjunction with docsQosParamSetMaxTrafficRate to
calculate maximum sustained traffic rate.
If the referenced parameter is not present in the
corresponding DOCSIS QOS Parameter Set, the default
value of this object for scheduling types
bestEffort (2), nonRealTimePollingService(3),
and realTimePollingService(4) is 1522.
If this parameter is not applicable, it is reported
as 0.
docsQosParamSetMaxTrafficBurst OBJECT-TYPE SYNTAX Gauge ACCESS read-only STATUS mandatory DESCRIPTION "Specifies the token bucket size in bytes for this parameter set. The value is calculated from the byte following the MAC header HCS to the end of the CRC. This object is applied in conjunction with docsQosParamSetMaxTrafficRate to calculate maximum sustained traffic rate. If the referenced parameter is not present in the corresponding DOCSIS QOS Parameter Set, the default value of this object for scheduling types bestEffort (2), nonRealTimePollingService(3), and realTimePollingService(4) is 1522. If this parameter is not applicable, it is reported as 0." REFERENCE "SP-RFIv1.1-I07-010829, Appendix C.2.2.5.3" ::= { docsQosParamSetEntry 7 }
Vendor: Cisco Systems
Module: DOCS-QOS-MIB (DOCS-QOS-MIB-V1SMI.my)
Type: TABULAR
Access: read-only
Syntax: Gauge
Automatically extracted from www.mibdepot.com
docsQosParamSetMaxTrafficBurst OBJECT-TYPE SYNTAX Unsigned32 MAX-ACCESS read-only STATUS current DESCRIPTION "Specifies the token bucket size in bytes for this parameter set. The value is calculated from the byte following the MAC header HCS to the end of the CRC. This object is applied in conjunction with docsQosParamSetMaxTrafficRate to calculate maximum sustained traffic rate. If the referenced parameter is not present in the corresponding DOCSIS QOS Parameter Set, the default value of this object for scheduling types bestEffort (2), nonRealTimePollingService(3), and realTimePollingService(4) is 1522. If this parameter is not applicable, it is reported as 0. " REFERENCE "SP-RFIv1.1-I07-010829, Appendix C.2.2.5.3" ::= { docsQosParamSetEntry 7 }
Internet Assigned Numbers Authority
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.2.1.10.127.7.1.2.1.4 | docsQosParamSetServiceClassName | 0 | 0 | Refers to the Service Class Name that the parameter set values were derived. If the referenced parameter is not present in the cor… |
| 1.3.6.1.2.1.10.127.7.1.2.1.5 | docsQosParamSetPriority | 0 | 0 | The relative priority of a service flow. Higher numbers indicate higher priority. This priority should only be used to differenti… |
| 1.3.6.1.2.1.10.127.7.1.2.1.6 | docsQosParamSetMaxTrafficRate | 0 | 0 | Maximum sustained traffic rate allowed for this service flow in bits/sec. Must count all MAC frame data PDU from the bytes follow… |
| 1.3.6.1.2.1.10.127.7.1.2.1.8 | docsQosParamSetMinReservedRate | 0 | 0 | Specifies the guaranteed minimum rate in bits/sec for this parameter set. The value is calculated from the byte following the MAC… |
| 1.3.6.1.2.1.10.127.7.1.2.1.9 | docsQosParamSetMinReservedPkt | 0 | 0 | Specifies an assumed minimum packet size in bytes for which the docsQosParamSetMinReservedRate will be provided. The value is cal… |
| 1.3.6.1.2.1.10.127.7.1.2.1.10 | docsQosParamSetActiveTimeout | 0 | 0 | Specifies the maximum duration in seconds that resources remain unused on an active service flow before CMTS signals that both ac… |
| 1.3.6.1.2.1.10.127.7.1.2.1.11 | docsQosParamSetAdmittedTimeout | 0 | 0 | Specifies the maximum duration in seconds that resources remain in admitted state before resources must be released. The value of … |
| 1.3.6.1.2.1.10.127.7.1.2.1.12 | docsQosParamSetMaxConcatBurst | 0 | 0 | Specifies the maximum concatenated burst in bytes which an upstream service flow is allowed. The value is calculated from the FC… |
| 1.3.6.1.2.1.10.127.7.1.2.1.13 | docsQosParamSetSchedulingType | 0 | 0 | Specifies the upstream scheduling service used for upstream service flow. If the referenced parameter is not present in the corres… |
| 1.3.6.1.2.1.10.127.7.1.2.1.15 | docsQosParamSetNomPollInterval | 0 | 0 | Specifies the nominal interval in microseconds between successive unicast request opportunities on an upstream service flow. This … |
| 1.3.6.1.2.1.10.127.7.1.2.1.16 | docsQosParamSetTolPollJitter | 0 | 0 | Specifies the maximum amount of time in microseconds that the unicast request interval may be delayed from the nominal periodic sc… |
| 1.3.6.1.2.1.10.127.7.1.2.1.17 | docsQosParamSetUnsolicitGrantSize | 0 | 0 | Specifies the unsolicited grant size in bytes. The grant size includes the entire MAC frame data PDU from the Frame Control byte … |
| 1.3.6.1.2.1.10.127.7.1.2.1.18 | docsQosParamSetNomGrantInterval | 0 | 0 | Specifies the nominal interval in microseconds between successive data grant opportunities on an upstream service flow. The refere… |
| 1.3.6.1.2.1.10.127.7.1.2.1.19 | docsQosParamSetTolGrantJitter | 0 | 0 | Specifies the maximum amount of time in microseconds that the transmission opportunities may be delayed from the nominal periodic… |
| 1.3.6.1.2.1.10.127.7.1.2.1.20 | docsQosParamSetGrantsPerInterval | 0 | 0 | Specifies the number of data grants per Nominal Grant Interval (docsQosParamSetNomGrantInterval). The referenced parameter is appl… |
| 1.3.6.1.2.1.10.127.7.1.2.1.21 | docsQosParamSetTosAndMask | 0 | 0 | Specifies the AND mask for IP TOS byte for overwriting IP packets TOS value. The IP packets TOS byte is bitwise ANDed with docsQ… |
| 1.3.6.1.2.1.10.127.7.1.2.1.22 | docsQosParamSetTosOrMask | 0 | 0 | Specifies the OR mask for IP TOS byte. See the description of docsQosParamSetTosAndMask for further details. |
| 1.3.6.1.2.1.10.127.7.1.2.1.23 | docsQosParamSetMaxLatency | 0 | 0 | Specifies the maximum latency between the reception of a packet by the CMTS on its NSI and the forwarding of the packet to the RF… |
| 1.3.6.1.2.1.10.127.7.1.2.1.24 | docsQosParamSetType | 0 | 0 | Defines the type of the QOS parameter set defined by this row. active(1) indicates the Active QOS parameter set, describing the s… |
| 1.3.6.1.2.1.10.127.7.1.2.1.25 | docsQosParamSetRequestPolicyOct | 0 | 0 | Specifies which transmit interval opportunities the CM omits for upstream transmission requests and packet transmissions. This ob… |
| 1.3.6.1.2.1.10.127.7.1.2.1.26 | docsQosParamSetBitMap | 0 | 0 | This object indicates the set of QOS Parameter Set parameters actually signaled in the DOCSIS registration or dynamic service req… |