This object, Trunk Conditioning during Carrier Group Alarm, specifies
what state the voice port assumes when the system enters a Carrier
Group Alarm state. It is not accessible for E&M voice ports with an
operating mode of Transmit Only. Accesses to those ports would result
in notApplicable(3) being returned.
Parsed from file pdndce.mib.txt
Company: paradyne
Module: PDNDCE-MIB
Vendor: Paradyne
Module: PDNDCE-MIB (pdndce.mib)
Type: TABULAR
Access: read-write
Syntax: INTEGER
Automatically extracted from www.mibdepot.com
devVoiceConfigTrunkCondInCGA OBJECT-TYPE SYNTAX INTEGER { idle (1), busy (2), notApplicable (3) } ACCESS read-write STATUS mandatory DESCRIPTION "This object, Trunk Conditioning during Carrier Group Alarm, specifies what state the voice port assumes when the system enters a Carrier Group Alarm state. It is not accessible for E&M voice ports with an operating mode of Transmit Only. Accesses to those ports would result in notApplicable(3) being returned." ::= { devVoiceConfigEntry 10 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.1 | devVoiceConfigIfIndex | 0 | 0 | This object specifies which row, in the devVoiceConfigTable, to use for mib access. It's value is identical to IfIndex. |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.2 | devVoiceConfigPortStatus | 0 | 0 | This object is used to control the voice port state. The states supported are disable(1) and enable(2). Attempts to set any othe… |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.3 | devVoiceConfigOperatingMode | 0 | 0 | This object is used to select the desired operating mode for the specified voice port. The type of input depends of the type of … |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.4 | devVoiceConfigSignalingType | 0 | 0 | This object is used to select the desired signaling type for the specified voice port. The type of input depends of the type of … |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.5 | devVoiceConfigWinkDelay | 0 | 0 | This object provides a method for selecting the amount of delay before a Wink signal is sent to the network when an off-hook sig… |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.6 | devVoiceConfigWinkDuration | 0 | 0 | This object provides a method for selecting the duration of the Wink signal being sent to the network as a result of detecting a… |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.7 | devVoiceConfigRxgain | 0 | 0 | This object allows selection of the receive path analog signal amplification on the specified voice port. The valid range depend… |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.8 | devVoiceConfigTxAttenuation | 0 | 0 | This object allows selection of the transmit path analog signal amplification on the specified voice port. The valid range depen… |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.9 | devVoiceConfigRingBackTone | 0 | 0 | This object enables the generation of an audible tone, referred to as ring-back, towards the network in response to an incoming … |
| 1.3.6.1.4.1.1795.2.24.2.6.4.1.1.11 | devVoiceConfigTermImpedance | 0 | 0 | This object specifies the terminating impedance for the port. The default value is 600 ohms(z600). Attempting to set values othe… |