Near end sending Alarm Indication Signal(AIS): a
signal sent down or up stream by a device
regarding an error condition from another unit in
the transmission path.
Parsed from file mariposa.mib.txt
Company: marconi
Module: MARIPOSA-MIB
Vendor: Marconi
Module: MARIPOSA-MIB (mariposa.mib)
Type: TABULAR
Access: read-only
Syntax: INTEGER
Automatically extracted from www.mibdepot.com
atmDs3E3PhyXmtAISFState OBJECT-TYPE SYNTAX INTEGER { yes (1), no (2) } ACCESS read-only STATUS mandatory DESCRIPTION "Near end sending Alarm Indication Signal(AIS): a signal sent down or up stream by a device regarding an error condition from another unit in the transmission path." ::= { atmDs3E3PhyParEntry 13 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.1 | atmDs3E3PhyParIfIndex | 0 | 0 | This value for this object is equal to the value of ifIndex from the Interfaces table of MIB II (RFC 1213). |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.2 | atmDs3E3PhyParInterfaceType | 0 | 0 | This object defines the interface type used. Valid values are: 1. Ds3 2. E3 |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.3 | atmDs3E3PhyParLineRate | 0 | 0 | This object defines the line rate in Mbps. Valid values are: 1. Ds3 interfaces: 44.736 2. E3 interfaces: 34.368 |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.4 | atmDs3E3PhyParLineCoding | 0 | 0 | This object specifies the type of zero code suppression used on the Ds3/E3 lines to maintain data integrity and reliability. Valid… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.5 | atmDs3E3PhyParLineLength | 0 | 0 | The length of the ds3 / e3 line. This object provides information for line build out circuitry if it exists and can be used to adj… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.6 | atmDs3E3PhyParLoopbackMode | 0 | 0 | This object defines the Loopback mode which may be the following 1. No Loopback Not in the loopback state. A device that is not ca… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.7 | atmDs3E3PhyParTxClockSource | 0 | 0 | The source of Transmit Clock for the Ds3/E3 UNI.. 'loopTiming' indicates that the recovered receive clock is used as the transmit… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.8 | atmDs3E3PhyParSystemClockSource | 0 | 0 | This object specifies the interface or link used as the Primary Reference Source for the system clock. This may be derived intern… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.9 | atmDs3E3PhyParSystemClockSourceStatus | 0 | 0 | This objects specifies whether the clock source defined by 'systemClockSource' is refering to a valid resource or not. If the spe… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.10 | atmDs3E3PhyParLossOfSignalState | 0 | 0 | Near end Loss Of Signal. The LOS failure is declared when the System cannot detect a signal at the ATM interface. When cells are … |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.11 | atmDs3E3PhyParLossOfFrameState | 0 | 0 | Near end LossOfFrame failure. The LOF failure is declared and this value is set to 'yes' (1) when framing bits have been lost at … |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.12 | atmDs3E3PhyAISFState | 0 | 0 | Far end sending Alarm Indication Signal(AIS): a signal sent down or up stream by a device regarding an error condition from anoth… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.14 | atmDs3E3PhyXmtFarEndLOFFState | 0 | 0 | This object specifies whether the Near End is transmitting a LOF signal detected at the far end. The LOF failure is declared and … |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.15 | atmDs3E3PhyRcvFarEndLOFFState | 0 | 0 | This object specifies whether the Near End is receiving a LOF signal from the far end. The LOF failure is declared and this value… |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.16 | atmDs3E3PhyPlcpLOFState | 0 | 0 | This object specifies whether or not the DS3 PLCP has declared a loss of frame (LOF) failure condition. |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.17 | atmDs3E3PhyPlcpOOFState | 0 | 0 | This object specifies whether or not the DS3 PLCP has declared an out of frame (OOF) failure condition. |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.18 | atmDs3E3PhyPlcpYellowState | 0 | 0 | This object specifies whether or not the DS3 PLCP has received an incoming Yellow Signal from the far end. |
| 1.3.6.1.4.1.2426.1.2.3.1.3.1.1.1.19 | atmDs3E3PhyPlcpXmtYellowState | 0 | 0 | This object specifies whether or not the DS3 PLCP has declared a loss of frame (LOF) failure condition, and begun transmitting th… |