This trap indicates when an interworking
PVC has experienced an alarmed condition,
either on the ATM network side or Frame Relay side.
Also it is generated when the PVC alarmed
condition is cleared. It carries the opera
tional status of the PVC by the frf8ConnOperStatus
as well as the reason why exiting,entering or
changing the alarmed state frf8ConnPVCAlarmReason.
If the interworking PVC changes its status by a
AdminStatus command (active/inactive/testing),
causing the frf8ConnOperStatus to change (up/down),
this trap will be generated with frf8ConnPVCAlarmReason
set to 'nodefect'. This TRAP will give the support
to manage defects that might occur in either Frame
Relay network or ATM network, even if the PVC Operational
Status is already down.
Parsed from file fore-frf8.mib.txt
Company: None
Module: Fore-frf8-MIB
This trap indicates when an interworking
PVC has experienced an alarmed condition,
either on the ATM network side or Frame Relay side.
Also it is generated when the PVC alarmed
condition is cleared. It carries the opera
tional status of the PVC by the frf8ConnOperStatus
as well as the reason why exiting,entering or
changing the alarmed state frf8ConnPVCAlarmReason.
If the interworking PVC changes its status by a
AdminStatus command (active/inactive/testing),
causing the frf8ConnOperStatus to change (up/down),
this trap will be generated with frf8ConnPVCAlarmReason
set to 'nodefect'. This TRAP will give the support
to manage defects that might occur in either Frame
Relay network or ATM network, even if the PVC Operational
Status is already down.
Parsed from file Fore-frf8-MIB.mib
Module: Fore-frf8-MIB
Vendor: Fore Systems, Inc.
Module: Fore-frf8-MIB
[Automatically extracted from oidview.com]
frf8PVCStatus NOTIFICATION-TYPE OBJECTS {frf8ConnFrServiceIfIndex,frf8ConnDlci, frf8ConnOperStatus,frf8ConnPVCAlarmReason } STATUS current DESCRIPTION "This trap indicates when an interworking PVC has experienced an alarmed condition, either on the ATM network side or Frame Relay side. Also it is generated when the PVC alarmed condition is cleared. It carries the opera tional status of the PVC by the frf8ConnOperStatus as well as the reason why exiting,entering or changing the alarmed state frf8ConnPVCAlarmReason. If the interworking PVC changes its status by a AdminStatus command (active/inactive/testing), causing the frf8ConnOperStatus to change (up/down), this trap will be generated with frf8ConnPVCAlarmReason set to 'nodefect'. This TRAP will give the support to manage defects that might occur in either Frame Relay network or ATM network, even if the PVC Operational Status is already down." ::= { atmSwitch 0 2000 }
frf8PVCStatus NOTIFICATION-TYPE OBJECTS {frf8ConnFrServiceIfIndex,frf8ConnDlci, frf8ConnOperStatus,frf8ConnPVCAlarmReason } STATUS current DESCRIPTION "This trap indicates when an interworking PVC has experienced an alarmed condition, either on the ATM network side or Frame Relay side. Also it is generated when the PVC alarmed condition is cleared. It carries the opera tional status of the PVC by the frf8ConnOperStatus as well as the reason why exiting,entering or changing the alarmed state frf8ConnPVCAlarmReason. If the interworking PVC changes its status by a AdminStatus command (active/inactive/testing), causing the frf8ConnOperStatus to change (up/down), this trap will be generated with frf8ConnPVCAlarmReason set to 'nodefect'. This TRAP will give the support to manage defects that might occur in either Frame Relay network or ATM network, even if the PVC Operational Status is already down." ::= { atmSwitch 0 2000 }
To many brothers! Only 100 nearest brothers are shown.
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| ... | ||||
| 1.3.6.1.4.1.326.2.2.0.2003 | framNakMsg | 0 | 0 | This trap is sent when a message from the SCP to the FRAM netmod does not succeed. |
| 1.3.6.1.4.1.326.2.2.0.2004 | pnniSpvccDown | 0 | 0 | This trap is sent when a SPVC call is cleared or deleted. The pnniSpvcSrcDownReason indicates if the call was cleared due to a be… |
| 1.3.6.1.4.1.326.2.2.0.2005 | pnniSpvccUp | 0 | 0 | This trap is send when a SPVC call is established. It identifies the SPVC and the old and new cost. If the call has not been up b… |
| 1.3.6.1.4.1.326.2.2.0.2006 | pnniSpvccFail | 0 | 0 | This trap is sent when a SPVC call that is down fails to get connected on 16 consecutive attempts. This trap is only sent if pnni… |
| 1.3.6.1.4.1.326.2.2.0.2007 | pnniSpvpcDown | 0 | 0 | This trap is sent when a SPVP call is cleared. The pnniSpvcSrcDownReason indicates if the call was cleared due to a better route … |
| 1.3.6.1.4.1.326.2.2.0.2008 | pnniSpvpcUp | 0 | 0 | This trap is send when a SPVP call is established. It identifies the SPVP and the old and new cost. If the call has not been up b… |
| 1.3.6.1.4.1.326.2.2.0.2009 | pnniSpvpcFail | 0 | 0 | This trap is sent when a SPVP call that is down fails to get connected on 16 consecutive attempts. This trap is only sent if pnni… |
| 1.3.6.1.4.1.326.2.2.0.2010 | asxPortCardDown | 0 | 0 | An asxPortCardDown trap signifies that the sending protocol entity recognizes a failure in one of the ATM Switch portcards, that … |
| 1.3.6.1.4.1.326.2.2.0.2011 | asxPortCardUp | 0 | 0 | An asxPortCardUp trap signifies that the sending protocol entity recognizes a new operational ATM Switch port card, that is ident… |
| 1.3.6.1.4.1.326.2.2.0.2013 | asxServiceCategoryOutputQueueCongested | 0 | 0 | This trap indicates that the output queue for the service category has exceeded its dedicated length, and has begun overflowing i… |
| 1.3.6.1.4.1.326.2.2.0.2014 | asxServiceCategoryOutputQueueCellLoss | 0 | 0 | This trap indicates that the output queue for the given service category has overflowed and cells have been dropped. |
| 1.3.6.1.4.1.326.2.2.0.2015 | pnniNormalToOverloadTransition | 0 | 0 | This trap is generated on transition from the normal state to the overload state. |
| 1.3.6.1.4.1.326.2.2.0.2016 | pnniOverloadToNormalTransition | 0 | 0 | This trap is generated on transition from the overload to the normal state. |
| 1.3.6.1.4.1.326.2.2.0.2017 | apsSwitchOver | 0 | 0 | This trap alerts that an aps switchover has occurred and the active port is identified by the tuple {hwPortBoard, hwPortModule, h… |
| 1.3.6.1.4.1.326.2.2.0.2018 | redundancyFabricSwitchover | 0 | 0 | This trap reports the change of active fabric due to an automatic or revertive switchover. The fabric identified by the trap vari… |
| 1.3.6.1.4.1.326.2.2.0.2019 | apsModeMismatchDeclare | 0 | 0 | This trap alerts that an aps mode mismatch has occurred on aps group. |
| 1.3.6.1.4.1.326.2.2.0.2020 | pnniPmpRerouteInitiated | 0 | 0 | This trap is sent when a party is being re-routed due to a better path being found or if a reroute is requested using a AMI comm… |
| 1.3.6.1.4.1.326.2.2.0.2021 | pnniPmpSpvcUp | 0 | 0 | This trap is send when a pmp SPVC call is established. This trap is only sent if pnniSpvcTrapMode is failure or all. |
| 1.3.6.1.4.1.326.2.2.0.2022 | pnniPmpSpvcDown | 0 | 0 | This trap is sent when a pmp SPVC call is cleared. The pnniSpvcSrcDownReason indicates if the call was cleared due to a better ro… |
| 1.3.6.1.4.1.326.2.2.0.2023 | pnniPmpSpvcFail | 0 | 0 | This trap is sent when a SPVC call that is down fails to get connected on 16 consecutive attempts. This trap is only sent if pnni… |
| 1.3.6.1.4.1.326.2.2.0.2024 | pnniSpvxRGroupSwover | 0 | 0 | This trap is sent when a automatic switch over occurs in a SPVC Redundancy group that has automatic PVC switch over enabled. |
| 1.3.6.1.4.1.326.2.2.0.2025 | asxSVXCPStateTransferFailed | 0 | 0 | This trap is sent when the SVx/SPVx Preservation module is unable to transfer call and interface state information to the Standby… |
| 1.3.6.1.4.1.326.2.2.0.2026 | asxSVXCPStateTransferRestarted | 0 | 0 | This trap is sent when the SVx/SPVx Preservation module has restarted its transfer of call and interface state information to the… |
| 1.3.6.1.4.1.326.2.2.0.2027 | asxSVXCPStateDroppedCall | 0 | 0 | This trap is sent when the SVx/SPVx Preservation module has insufficient memory to store one or more calls during its transfer of… |
| 1.3.6.1.4.1.326.2.2.0.2028 | apsModeMismatchClear | 0 | 0 | This trap alerts that an aps mode mismatch has cleared on aps group. |
| 1.3.6.1.4.1.326.2.2.0.2040 | elecredSwitchOver | 0 | 0 | This trap alerts that an electrical redundancy switchover has occurred and the active port is identified by the tuple {hwPortBoa… |
| 1.3.6.1.4.1.326.2.2.0.2050 | asxVPOAMAISDetected | 0 | 0 | This trap indicates that the Alarm Indication Signal (AIS) is detected on the incoming (terminating) virtual path. This trap is … |
| ... | ||||