Defines the FUTURE Service Set IDentifier to be used for the
BSS.
The term future means that a change takes effect after the
next reset of the Access Point. The current BSSID can be
obtained from dot11DesiredSSID.
Parsed from file RoamAbout-MIB.mib
Module: RoamAbout-MIB
Vendor: DEC
Module: RoamAbout-MIB
[Automatically extracted from oidview.com]
rabtDot11FutureNetworkName OBJECT-TYPE SYNTAX DisplayString (SIZE (1..32)) ACCESS read-write STATUS mandatory DESCRIPTION "Defines the FUTURE Service Set IDentifier to be used for the BSS. The term future means that a change takes effect after the next reset of the Access Point. The current BSSID can be obtained from dot11DesiredSSID." ::= { rabtDot11Future 2 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.36.2.18.35.15.2.1 | rabtDot11FutureChannel | 0 | 0 | Defines the FUTURE channel (communication frequency) to be used for creating a BSS. Note that different subsets of channels are … |
| 1.3.6.1.4.1.36.2.18.35.15.2.3 | rabtDot11FutureStationName | 0 | 0 | Defines the FUTURE station name of the radio interface, used by client utilities. The term future means that a change takes effec… |
| 1.3.6.1.4.1.36.2.18.35.15.2.4 | rabtDot11FutureOperationalRate | 0 | 0 | This attribute shall specify the set of data rates at which the station may transmit data. Each octet contains a value represent… |
| 1.3.6.1.4.1.36.2.18.35.15.2.5 | rabtDot11FutureSystemScale | 0 | 0 | Specifies the FUTURE Access Point density in the ESS. The term future means that the change takes effect after the next reset of … |
| 1.3.6.1.4.1.36.2.18.35.15.2.6 | rabtDot11FutureDTIMPeriod | 0 | 0 | Defines the FUTURE number of beacon intervals between successive DTIMs. The term future means that a change takes effect after t… |
| 1.3.6.1.4.1.36.2.18.35.15.2.7 | rabtDot11FutureFragmentationThreshold | 0 | 0 | This attribute shall specify the mandatory maximum size, in octets, of the MPDU that may be delivered to the PHY. An MSDU shall b… |
| 1.3.6.1.4.1.36.2.18.35.15.2.8 | rabtDot11FutureRTSThreshold | 0 | 0 | This attribute shall indicate the number of octets in an MPDU, below which an RTS/CTS handshake shall not be performed. An RTS/CT… |
| 1.3.6.1.4.1.36.2.18.35.15.2.9 | rabtDot11FutureMulticastPMBuffering | 0 | 0 | Defines if multicast MAC frames are to be buffered for transmission after DTIM in the FUTURE. If disabled, MAC frames will be im… |
| 1.3.6.1.4.1.36.2.18.35.15.2.10 | rabtDot11FutureSecureAccess | 0 | 0 | When this mode is set to enabled, the AP will only associate with stations that have the same network name as the AP. When this m… |
| 1.3.6.1.4.1.36.2.18.35.15.2.11 | rabtDot11FutureTransmitRate | 0 | 0 | This value specifies the transmission rate of the AP. It is implemented when cards that operate faster than the 2Mbit 802.11 stan… |
| 1.3.6.1.4.1.36.2.18.35.15.2.12 | rabtDot11FuturePrivacyInvoked | 0 | 0 | This value specifies the future setting of the dot11PrivacyInvoked attribute in the AP. |
| 1.3.6.1.4.1.36.2.18.35.15.2.13 | rabtDot11FutureExcludeUnencrypted | 0 | 0 | This value specifies the future value of the dot11ExcludeUnencrypted attribute in the AP. |