Used to set the interface to analyzer mode. When enabled(1), all IP
packets entering this interface and all non-mirror IP packets leaving
this interface will be dropped. The value default(2) specifies that
this interface will be the default analyzer port for the virtual-router
where the interface resides.
Parsed from file juniIp.mi2.txt
Company: None
Module: Juniper-IP-MIB
Used to set the interface to analyzer mode. When enabled(1), all IP
packets entering this interface and all non-mirror IP packets leaving
this interface will be dropped. The value default(2) specifies that
this interface will be the default analyzer port for the virtual-router
where the interface resides.
Parsed from file Juniper-IP-MIB.mib
Module: Juniper-IP-MIB
Vendor: Juniper Networks/Unisphere
Module: Juniper-IP-MIB
[Automatically extracted from oidview.com]
juniIpIfAnalyzerMode OBJECT-TYPE SYNTAX INTEGER { disable(0), enable(1), default(2) } MAX-ACCESS read-create STATUS current DESCRIPTION "Used to set the interface to analyzer mode. When enabled(1), all IP packets entering this interface and all non-mirror IP packets leaving this interface will be dropped. The value default(2) specifies that this interface will be the default analyzer port for the virtual-router where the interface resides." DEFVAL { disable } ::= { juniIpIfEntry 29 }
juniIpIfAnalyzerMode OBJECT-TYPE SYNTAX INTEGER { disable(0), enable(1), default(2) } MAX-ACCESS read-create STATUS current DESCRIPTION "Used to set the interface to analyzer mode. When enabled(1), all IP packets entering this interface and all non-mirror IP packets leaving this interface will be dropped. The value default(2) specifies that this interface will be the default analyzer port for the virtual-router where the interface resides." DEFVAL { disable } ::= { juniIpIfEntry 29 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.1 | juniIpIfIndex, usdIpIfIndex | 0 | 0 | The ifIndex of the IP interface. When creating entries in this table, suitable values for this object are determined by reading… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.2 | juniIpIfRowStatus, usdIpIfRowStatus | 0 | 0 | Controls creation/deletion of entries in this table according to the RowStatus textual convention, constrained to support the fo… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.3 | juniIpIfLowerIfIndex, usdIpIfLowerIfIndex | 0 | 0 | The ifIndex of a media interface over which this IP interface is to be layered. A value of zero is used when usdIpIfType is spe… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.4 | juniIpIfType, usdIpIfType | 0 | 0 | juniIpIftype |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.5 | juniIpIfTypeId, usdIpIfTypeId | 0 | 0 | juniIpIftypeId |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.6 | juniIpIfSAValidationEnable, usdIpIfSAValidationEnable | 0 | 0 | Enable/disable source address validation on this IP network interface. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.7 | juniIpIfCreationType, usdIpIfCreationType | 0 | 0 | Specify if the interface was created due to static configuration or due to some dynamic event. Dynamic interfaces are not store… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.8 | juniIpIfProfileId, usdIpIfProfileId | 0 | 0 | Identified the profile used when creating a dynamic interface. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.9 | juniIpIfAlwaysUp, usdIpIfAlwaysUp | 0 | 0 | When enabled, the interface is determined to be up regardless of the state of any lower layer interfaces. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.10 | juniIpIfLoopback, usdIpIfLoopback | 0 | 0 | Indicates whether the interface is a loopback type interface. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.11 | juniIpIfLoopbackUid, usdIpIfLoopbackUid | 0 | 0 | Specify the interface index of a loopback interface whose IP address should be used when sourcing traffic on this interface. Us… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.12 | juniIpIfDebounceTime, usdIpIfDebounceTime | 0 | 0 | Specifies the time in milliseconds that a layer 2 interface must remain in a state before it is conveyed to the IP layer. Usefu… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.13 | juniIpIfForwarding, usdIpIfForwarding | 0 | 0 | Enable/disable the forwarding of IP traffic to/from this interface. This is currently only applicable to the out-of-band managem… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.14 | juniIpIfForceFragmentation, usdIpIfForceFragmentation | 0 | 0 | Force the fragmentation of all IP packets greater than the interface MTU even if the DF bit is set. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.15 | juniIpIfSharesLowerUid, usdIpIfSharesLowerUid | 0 | 0 | Identifies the interface as sharing a lower interface with another interface vs owning it outright. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.16 | juniIpIfFilterOptions, usdIpIfFilterOptions | 0 | 0 | Bit mask to configure the interface to filter packets with IP header options. Currently, either no bits or all bits may be set. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.17 | juniIpIfName, usdIpIfName | 0 | 0 | Specify the IP interface discriminator for an IP interface not attached to a layer 2 interface with a specific location. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.18 | juniIpIfArpTimeout, usdIpIfArpTimeout | 0 | 0 | Specify the ARP timeout for this interface in seconds. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.19 | juniIpIfAdminSpeed, usdIpIfAdminSpeed | 0 | 0 | Set an administrative speed for the interface that overrides the speed learned from the lower layer. A value of 0 indicates no … |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.20 | juniIpIfMultipathMode, usdIpIfMultipathMode | 0 | 0 | Configure the mode this interface should use when forwarding equal-cost multipath traffic. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.21 | juniIpIfSharedNhAddr, usdIpIfSharedNhAddr | 0 | 0 | The IP address of either a direct or indirect next-hop toward which this shared interface should point. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.22 | juniIpIfSharedNhRouterId, usdIpIfSharedNhRouterId | 0 | 0 | The identifier for the domain of a virtual router in which the usdIpIfSharedNhAddr should be resolved. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.23 | juniIpIfPrimaryIpAddress, usdIpIfPrimaryIpAddress | 0 | 0 | The IP address of the primary IP network on an interface. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.24 | juniIpIfPrimaryIpMask, usdIpIfPrimaryIpMask | 0 | 0 | The IP address mask of the primary IP network on an interface. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.25 | juniIpIfOperDebounceTime, usdIpIfOperDebounceTime | 0 | 0 | Indicates the operational time in milliseconds that a layer2 interface must remain in a state before it is conveyed to the IP la… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.26 | juniIpIfRouterIndex | 0 | 0 | The index or ID of the router. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.27 | juniIpIfInheritNum | 0 | 0 | Indicates whether this numbered interface is referenced by unnumbered interfaces. |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.28 | juniIpIfInheritNumUid | 0 | 0 | Specify the interface index of a numbered interface whose IP address should be used when sourcing traffic on this interface. Us… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.30 | juniIpIfAutoConfigure | 0 | 0 | When enabled, IP subscriber interfaces are created dynamically based on any attributes defined in the service-profile and the ru… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.31 | juniIpIfTcpMss | 0 | 0 | juniIpIftcpMss |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.32 | juniIpIfInitSeqPrefOper | 0 | 0 | Indicates the operational warm-restart replay initial sequence preference value for an IP interface. Following an HA SRP switch… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.33 | juniIpIfInitSeqPrefAdmin | 0 | 0 | Configures the warm-restart replay initial sequence preference value for an IP interface. See the juniIpIfInitSeqPrefOper descr… |
| 1.3.6.1.4.1.4874.2.2.12.1.1.2.1.34 | juniIpIfArpSpoofCheck | 0 | 0 | When enabled, IP ARP spoof checking is performed on ARP packets received on the IP interface. |