Status in source: current.
Technical details
{
"smi_kind": "OBJECT-TYPE",
"definition": [
"fsLaPortChannelSelectionPolicyBitList",
"OBJECT-TYPE",
"SYNTAX",
"Integer32",
"MAX-ACCESS",
"read-write",
"STATUS",
"current",
"DESCRIPTION",
"\"This object is used to set the link selection policy to be used by the port-channel. A four byte integer is used for setting the selecting policy. Each bit in the four byte integer represents a particular selection policy. The mapping between the bit positions & the selection policy is as follows: macSrc(0), -- source MAC macDst(1), -- destination MAC vlanId(2), -- VLAN ID isid(3), -- ISID mplsLabel0(4), -- MPLS Label 0 ( top label ) mplsLabel1(5), -- MPLS Label 1 ( inner label 1) mplsLabel2(6), -- MPLS Label 2 ( inner label 2) ipSrc(7), -- Source IP address ipDst(8), -- Destination IP address ip6Src(9), -- Source IPv6 address ip6Dst(10), -- Destination IPv6 address l3Protocol(11),-- Layer 3 protocol specified in IP header l4SrcPort(12), -- Layer 4 source port specified in L4 header ( tcp/udp port ) l4DstPort (13),-- Layer 4 destination port specified in L4 header ( tcp/udp port ) enhanced(14), -- enhanced hashing-based load balance specific to platform randomized(15) -- randomized load balance specific to platform The remaining bits are unused. Selection of multiple bits implies selection of corresponding attributes in the packet header for configuring the port-channel selection policy. For example, if the bits 0 and 1 are set, then the selection policy is based on source MAC and destination MAC. This object would return failure if the selected bit list is not supported in the system(hardware).\"",
"::=",
"{",
"fsLaPortChannelEntry",
"11",
"}"
],
"syntax_tree": [
[
"SimpleSyntax",
"Integer32"
],
null,
[
"MaxAccessPart",
"read-write"
],
[
"Status",
"current"
],
[
"DESCRIPTION",
"This object is used to set the link selection policy to be used by the port-channel. A four byte integer is used for setting the selecting policy. Each bit in the four byte integer represents a particular selection policy. The mapping between the bit positions & the selection policy is as follows: macSrc(0), -- source MAC macDst(1), -- destination MAC vlanId(2), -- VLAN ID isid(3), -- ISID mplsLabel0(4), -- MPLS Label 0 ( top label ) mplsLabel1(5), -- MPLS Label 1 ( inner label 1) mplsLabel2(6), -- MPLS Label 2 ( inner label 2) ipSrc(7), -- Source IP address ipDst(8), -- Destination IP address ip6Src(9), -- Source IPv6 address ip6Dst(10), -- Destination IPv6 address l3Protocol(11),-- Layer 3 protocol specified in IP header l4SrcPort(12), -- Layer 4 source port specified in L4 header ( tcp/udp port ) l4DstPort (13),-- Layer 4 destination port specified in L4 header ( tcp/udp port ) enhanced(14), -- enhanced hashing-based load balance specific to platform randomized(15) -- randomized load balance specific to platform The remaining bits are unused. Selection of multiple bits implies selection of corresponding attributes in the packet header for configuring the port-channel selection policy. For example, if the bits 0 and 1 are set, then the selection policy is based on source MAC and destination MAC. This object would return failure if the selected bit list is not supported in the system(hardware)."
],
null,
null,
null,
null
]
}