| 1.3.6.1.4.1.326.2.8.1.2.1.1.1 |
tsFwVer | 1 | 1 |
The firmware version in the form major.minor. For
port microcode (SOLO) version information see the
mgmt.mib-2.interfaces.ifTable… |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.2 |
tsHwVer | 1 | 1 |
The hardware version in the form major.minor. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.3 |
tsSerialNumber | 1 | 1 |
System serial number. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.4 |
tsInstallationDate | 1 | 1 |
Firmware installation date. This date is initially
set by the Network Management station. Each time
the NV RAM is cleared through… |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.5 |
tsFwSize | 1 | 1 |
Size in bytes of the binary firmware image. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.6 |
tsFwCRC | 1 | 1 |
Firmware binary image CRC value. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.7 |
tsFwManufacturer | 1 | 1 |
Firmware manufacturer. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.8 |
tsIpAddr | 1 | 1 |
IP address of the switch. Changes to this object
take effect immediately. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.9 |
tsNetMask | 1 | 1 |
IP subnet mask of the switch. Changes to this object
take effect immediately. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.10 |
tsDefaultGateway | 1 | 1 |
IP default gateway used by the switch. Changes to this
object take effect immediately. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.14 |
tsTrapRcvrTable | 1 | 6 |
A table of managers to which to send traps.
Entries in the table are saved across resets and
power cycles. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.19 |
tsPingInterval | 1 | 1 |
This variable specifies the interval in seconds of
sending ICMP Echo Requests to the default gateway.
No PING packets will be sen… |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.20 |
tsTapPort | 1 | 1 |
Select the port to monitor traffic. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.21 |
tsTapMonitoredPort | 1 | 1 |
Allows the selection of the port that will be monitored by the
port selected by tsTapPort. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.23 |
tsCrcThresholdLow | 1 | 1 |
Threshold for the switch to change to store and
forward mode. A change in mode also generates a trap. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.24 |
tsPortSwitchModeChangeTrapEnable | 1 | 1 |
Enable or disable the trap sent out when the switching
mode changes from cut-through to store and forward. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.25 |
tsTrendThreshold | 1 | 1 |
Based on trend calculation of the Dynamic Cut State
algorithm, when this value is exceeded the port
changes from cut-through to s… |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.26 |
tsSamplingPeriod | 1 | 1 |
Sampling period in minutes for determining if the
error rate of CRC errors has been exceeded.
The default value for this object i… |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.27 |
tsNumberUFC | 1 | 1 |
The number of UFCs installed in the switch. A value
of zero indicates there are NO UFCs installed in this switch.
This value ind… |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.28 |
tsMibLvl | 1 | 1 |
The current MIB Level supported by the switch. |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.29 |
tsMgrDomain | 1 | 1 |
The domain number used in responding to SNMP requests (get/next/set)
for multiple instance MIBs such as the Bridge MIB (RFC1493)… |
| 1.3.6.1.4.1.326.2.8.1.2.1.1.30 |
tsEmbeddedRmonStatus | 1 | 1 |
The current status of the embedded RMON feature. The
The embedded RMON feature may be enabled or disabled by
setting this object. |