Range is 0..100, where 0 = quietest possible, and 100 =
loudest possible. A device shall divide this value into
ranges corresponding to the possible volumes.
Additional information:
For HP Laserjet 3200 the range is 0..200, where 0=off (silent),
96=soft, 160=medium, and 200=loud.
For HP Laserjet 3200 this object refers to the line monitor
noise volume. The decimal values above correspond
to the hex values the object gets set to.
Parsed from file lj3200_snmp.mib.txt
Company: hp
Module: LJ3200-MIB
Child arc 0 is used to translate between SNMPv1 and SNMPv2 notification parameters as explained in IETF RFC 2576, section 3.
fax-noise-volume OBJECT-TYPE SYNTAX INTEGER(0..200) ACCESS read-write STATUS optional DESCRIPTION "Range is 0..100, where 0 = quietest possible, and 100 = loudest possible. A device shall divide this value into ranges corresponding to the possible volumes. Additional information: For HP Laserjet 3200 the range is 0..200, where 0=off (silent), 96=soft, 160=medium, and 200=loud. For HP Laserjet 3200 this object refers to the line monitor noise volume. The decimal values above correspond to the hex values the object gets set to." ::= { settings-fax-proc-sub 3 }
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.3.0 | fax-noise-volume | 0 | 0 | None |
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.1 | fax-rxscale | 1 | 1 | Received faxes are to be printed at a reduced scale percentage. Value of 0 indicates auto-scaled printing based on the length of… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.6 | fax-download | 1 | 1 | Note: Changed enumeration values in a non-backwards manner in version 4.7. Handshake mechanism between host and device to initi… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.7 | fax-silent-detection | 1 | 1 | When enabled, this object causes the FAX machine to assume that the caller is a FAX even though the line has remained silent for … |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.8 | fax-ring-enable | 1 | 1 | When the phone line rings, this object determines whether an audible ring shall be emitted. |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.9 | fax-country | 1 | 1 | Note: Non-backwards compatible change make in version 4.7. Returns which country the telephone-electronics (LIU) is configured … |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.10 | fax-tx-phone-number | 1 | 1 | Phone number about to be dialed. |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.14 | fax-redial-time | 1 | 1 | Number of seconds one must wait between the current redial (set by FAX-WHICH-REDIAL) and any prior dialing. |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.18 | fax-pstn-access-code | 1 | 1 | The code used within a PBX to get access to an outside PSTN line. Typically this is ''9''. |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.19 | fax-rx-disposition | 1 | 1 | Indicates what is to be done with the incoming fax call. ePrintOnly - New fax arrivals only go to the printer. If printer becomes … |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.21 | fax-error-correction-mode | 1 | 1 | Indicates whether the device is configured to send and receive faxes in error correction mode (ECM). This object controls both re… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.22 | fax-report-transmission | 1 | 1 | Provides a host application with the ability to print a fax transmission report. The supported enumerations are: eNone - no trans… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.23 | fax-report-activity-log | 1 | 1 | Specifies when a report of fax transactions is to be printed. eNever - to never print a transaction report. eThreshold - to autom… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.24 | fax-dial-tone-detection | 1 | 1 | Determines whether the fax machine waits for a dial tone before dialing a fax number. eEnabled - causes the fax machine to wait u… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.25 | fax-alarm-volume | 1 | 1 | Range is 0..100, where 0 = quietest possible, and 100 = loudest possible. A device shall divide this value into ranges correspond… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.26 | fax-beep-volume | 1 | 1 | Range is 0..100, where 0 = quietest possible, and 100 = loudest possible. A device shall divide this value into ranges correspond… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.27 | fax-ring-volume | 1 | 1 | Range is 0..100, where 0 = quietest possible, and 100 = loudest possible. A device shall divide this value into ranges correspond… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.28 | fax-master-host | 1 | 1 | Identifies the hostname of the master host to which the device is connected. |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.29 | fax-thumbnail-enable | 1 | 1 | Controls whether or not a thumbnail reprint of the first page of a fax shall be included on the fax call report. When set to eEn… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.30 | fax-phone-pickup-enable | 1 | 1 | This object is included to handle the situation where a fax machine and a telephone share the same phone line. If a call picked … |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.31 | fax-adf-scan-count | 1 | 1 | This object tracks the page count for the pages scanned for faxing from the ADF. In order to write this object SERVICE-PASSWORD … |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.32 | fax-print-page-count | 1 | 1 | This object tracks the page count for the pages sent to the print engine for fax jobs. In order to write this object SERVICE-PAS… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.33 | fax-download-page-count | 1 | 1 | This object tracks the page count for the pages downloaded to the peripheral for fax jobs. In order to write this object SERVICE… |
1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.34 | fax-upload-page-count | 1 | 1 | This object tracks the page count for the pages uploaded from the peripheral for fax jobs. In order to write this object SERVICE… |