Vendor: Bintec
Module: BIANCA-XL-MIBSYS-MIB (mibsysxl.mib)
Type: OBJ ID
Access:
Syntax:
Automatically extracted from www.mibdepot.com
sysConfig OBJECT IDENTIFIER ::= { bibo 15 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.272.4.15.1 | sysConfigLcdBrightness | 1 | 1 | This variable allows to control the brightness of the LCD display. Lower values mean less, higher values mean more brightness. Ze… |
| 1.3.6.1.4.1.272.4.15.2 | sysConfigLcdContrast | 1 | 1 | This variable allows to control the contrast of the LCD display. Lower values mean less, higher values mean more contrast. Zero m… |
| 1.3.6.1.4.1.272.4.15.3 | sysConfigLcdConfigure | 1 | 1 | This variable determines whether it is possible to configure the brick by using the LCD display and the buttons. |
| 1.3.6.1.4.1.272.4.15.4 | sysConfigTemperature | 1 | 1 | This variable shows the actual system temperature measured inside the brick in the units Fahrenheit or Celsius. |
| 1.3.6.1.4.1.272.4.15.5 | sysConfigTempUnit | 1 | 1 | This variable defines the unit of sysConfigTemperature, either Celsius or Fahrenheit. |
| 1.3.6.1.4.1.272.4.15.6 | sysConfigTempAlarmTrap | 1 | 1 | If the system temperature raises above this threshold, a alarm trap is generated every 60 seconds. |
| 1.3.6.1.4.1.272.4.15.7 | sysConfigTempAlarmRelay | 1 | 1 | If the system temperature raises above this threshold, the alarm relay is activated. It is deactivated again when the system temp… |
| 1.3.6.1.4.1.272.4.15.8 | sysConfigFanControl | 1 | 1 | This variable defines automatic fan control. In mode 'auto' the fans are automatically adjusted depending on the current temperat… |
| 1.3.6.1.4.1.272.4.15.9 | sysConfigFan1 | 1 | 1 | This variable shows, whether the fan is turning or not. |
| 1.3.6.1.4.1.272.4.15.10 | sysConfigFan2 | 1 | 1 | This variable shows, whether the fan is turning or not. |
| 1.3.6.1.4.1.272.4.15.11 | sysConfigFan3 | 1 | 1 | This variable shows, whether the fan is turning or not. |
| 1.3.6.1.4.1.272.4.15.12 | sysConfigFan4 | 1 | 1 | This variable shows, whether the fan is turning or not. |