This variable counts the number of occurrences of events
that have an associated SNMP trap, and no trap was sent
due to the 'trapControl' trap filter since the date and
time specified by 'trapClearDate'. When the filter check
was performed, either 'trapControl' was set to 'disabled';
or 'trapControl' was set to 'feedbackPinLimited' and
'trapFlow' was set to 'closed'.
This non-persistent variable is set to 0 whenever the
Network Management Unit, or NMU, processor is reset.
This counter can be cleared by setting 'trapClearDate'.
The Agent determines if a trap can be sent by examining
several controls (or filters), all of which enable the
sending of the trap. These are described in their order
of checking below:
One, the MIB variable that enables that specific trap to be
sent is enabled. (Each trap can be selectively enabled or
disabled.) If a trap is not sent due to this filter, then
'trapFilteredSpecific' is incremented.
Two, the MIB 'trapControl', is set to 'unLimited'; or, it
is set to 'feedbackPinLimited' and 'trapFlow' is set to
'open'. If a trap is not sent due to this filter, then
'trapFilteredControl' is incremented.
Three, one or more trap managers must be defined in the
table 'trapMgrTable' with a valid IP address in
'trapMgrTable.trapMgrAddress', and their control variable
'trapMgrTable.trapMgrControl' must be configured to 1)
'both' or 'standard' and the trap is a standard trap; or 2)
'enterprise' or 'both', and the trap is an enterprise trap.
If a trap is not sent due to this filter, then
'trapFilteredManager' is incremented.
Four, the trap has no associated severity level, or the
severity level of the trap is equal or higher than the
value specified by the severity filter
'trapSeverityFilter'. If a trap is not sent due to this
filter, then 'trapFilteredSeverity' is incremented.
Parsed from file WESTERN-MULTIPLEX-MIB.mib
Module: WESTERN-MULTIPLEX-MIB
Vendor: Western Multiplex
Module: WESTERN-MULTIPLEX-MIB
[Automatically extracted from oidview.com]
trapFilteredControl OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "This variable counts the number of occurrences of events that have an associated SNMP trap, and no trap was sent due to the 'trapControl' trap filter since the date and time specified by 'trapClearDate'. When the filter check was performed, either 'trapControl' was set to 'disabled'; or 'trapControl' was set to 'feedbackPinLimited' and 'trapFlow' was set to 'closed'. This non-persistent variable is set to 0 whenever the Network Management Unit, or NMU, processor is reset. This counter can be cleared by setting 'trapClearDate'. The Agent determines if a trap can be sent by examining several controls (or filters), all of which enable the sending of the trap. These are described in their order of checking below: One, the MIB variable that enables that specific trap to be sent is enabled. (Each trap can be selectively enabled or disabled.) If a trap is not sent due to this filter, then 'trapFilteredSpecific' is incremented. Two, the MIB 'trapControl', is set to 'unLimited'; or, it is set to 'feedbackPinLimited' and 'trapFlow' is set to 'open'. If a trap is not sent due to this filter, then 'trapFilteredControl' is incremented. Three, one or more trap managers must be defined in the table 'trapMgrTable' with a valid IP address in 'trapMgrTable.trapMgrAddress', and their control variable 'trapMgrTable.trapMgrControl' must be configured to 1) 'both' or 'standard' and the trap is a standard trap; or 2) 'enterprise' or 'both', and the trap is an enterprise trap. If a trap is not sent due to this filter, then 'trapFilteredManager' is incremented. Four, the trap has no associated severity level, or the severity level of the trap is equal or higher than the value specified by the severity filter 'trapSeverityFilter'. If a trap is not sent due to this filter, then 'trapFilteredSeverity' is incremented." ::= { trap 19 }
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.3727.20.10.5.1 | trapControl | 0 | 0 | This persistent variable controls the generation of SNMP traps by the Agent within the NMU of the radio. 'disabled' forces the Ag… |
| 1.3.6.1.4.1.3727.20.10.5.2 | trapClearDate | 0 | 0 | The SNMP user writing any value to this variable, causes the following variables to be modified: 1) 'trapMgrCounter' variables of… |
| 1.3.6.1.4.1.3727.20.10.5.3 | trapMgrTable | 1 | 5 | This table contains a list of trap managers that the Agent must attempt to sent its traps, assuming other controls (or filters) a… |
| 1.3.6.1.4.1.3727.20.10.5.4 | trapFlow | 0 | 0 | This variable indicates whether the Agent has its ability to send SNMP traps limited because it has sent 'trapMaxPerWindow' traps… |
| 1.3.6.1.4.1.3727.20.10.5.5 | trapLastTimestamp | 0 | 0 | This variable contains the Date and Time that the Agent attempted to send the last trap. (The time the Agent formatted the SNMP t… |
| 1.3.6.1.4.1.3727.20.10.5.6 | trapWindowPeriod | 0 | 0 | This persistent variable indicates the time period in minutes that is used by the feedback/pin trap limiting algorithm as specifi… |
| 1.3.6.1.4.1.3727.20.10.5.7 | trapMaxPerWindow | 0 | 0 | This persistent variable indicates the maximum number of traps that can occur and be sent during the time period specified by 'tr… |
| 1.3.6.1.4.1.3727.20.10.5.10 | trapSequenceClearDate | 0 | 0 | The SNMP user writing any value to this variable, causes the following variables to be modified: 1) 'trapSequenceNumber' variable… |
| 1.3.6.1.4.1.3727.20.10.5.11 | trapSequenceNumber | 0 | 0 | This persistent variable increments every time an enterprise or standard trap (coldStart, LinkUp, etc.) is generated by the Netwo… |
| 1.3.6.1.4.1.3727.20.10.5.12 | trapSeverityFilter | 0 | 0 | This persistent variable indicates the desired severity level for sending a generated SNMP trap based upon this severity level. T… |
| 1.3.6.1.4.1.3727.20.10.5.13 | trapCommunity | 0 | 0 | This persistent variable identifies the community string to be used when sending traps to any of the trap managers specified in '… |
| 1.3.6.1.4.1.3727.20.10.5.18 | trapFilteredSpecific | 0 | 0 | This variable counts the number of occurrences of events that have an associated SNMP trap, and no trap was sent due to a trap fi… |
| 1.3.6.1.4.1.3727.20.10.5.20 | trapFilteredManager | 0 | 0 | This variable counts the number of occurrences of events that have an associated SNMP trap, and no trap was sent due to the 'trap… |
| 1.3.6.1.4.1.3727.20.10.5.21 | trapFilteredSeverity | 0 | 0 | This variable counts the number of occurrences of events that have an associated SNMP trap, and no trap was sent due to the trap … |
| 1.3.6.1.4.1.3727.20.10.5.22 | trapColdStartControl | 0 | 0 | This persistent variable controls whether the Agent will attempt to sent a trap the MIB II 'coldStart' trap whenever the Network … |
| 1.3.6.1.4.1.3727.20.10.5.23 | trapLinkDownControl | 0 | 0 | This persistent variable controls whether the Agent will attempt to sent a trap the MIB II 'linkDown' trap whenever the Network M… |
| 1.3.6.1.4.1.3727.20.10.5.24 | trapLinkUpControl | 0 | 0 | This persistent variable controls whether the Agent will attempt to sent a trap the MIB II 'linkUp' trap whenever the Network Man… |