| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.1 |
switchPortStatsGroupID | 0 | 0 |
The group ID of the switch module port being referenced. If the
group is not present, or if there is no switch module installed
… |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.3 |
switchPortReadableFrames | 0 | 0 |
The number of valid frames received by the port. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.4 |
switchPortReadableOctets | 0 | 0 |
The number of octets (bytes) in all valid frames received
by the port. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.5 |
switchPortFCSErrors | 0 | 0 |
The number of valid-length frames received by the port that
had FCS (frame check sequence) errors. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.6 |
switchPortAlignmentErrors | 0 | 0 |
The number of valid-length frames received by the port that
had alignment errors. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.7 |
switchPortFramesTooLong | 0 | 0 |
The number of frames received by the port that were longer
than 1518 bytes. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.8 |
switchPortShortEvents | 0 | 0 |
The number of frames received by the port that were shorter
than 82 bits. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.9 |
switchPortRunts | 0 | 0 |
The number of frames received by the port that were longer
than 82 bits but shorter than 512 bits (64 bytes). |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.10 |
switchPortCollisions | 0 | 0 |
The number of collisions detected on the port. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.11 |
switchPortLateEvents | 0 | 0 |
The number of collisions detected on the port that occurred
later than 512 bit-times into the transmission of a packet. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.12 |
switchPortVeryLongEvents | 0 | 0 |
The number of times any activity continued for more than
4 to 7.5 milliseconds. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.13 |
switchPortDataRateMismatches | 0 | 0 |
The number of times the incoming data rate mismatched the local
clock source enough to cause a FIFO overflow or underflow. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.14 |
switchPortAutoPartitions | 0 | 0 |
The number of times this port was auto-partitioned by the
hardware. In 100Mbps mode, a port auto-partitions when it
detects more… |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.15 |
switchPortBroadcastPackets | 0 | 0 |
The number of good broadcast frames received by the port. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.16 |
switchPortMulticastPackets | 0 | 0 |
The number of good multicast (not broadcast) frames received
by the port. |
| 1.3.6.1.4.1.52.259.10.3.4.2.1.1.17 |
switchPortIsolates | 0 | 0 |
The number of times this port was auto-isolated by the hardware.
This occurs only during 100Mbps operation. A port auto-isolate… |