The administrative status of Uni Directional NAT. The value
`enabled' denotes that the Uni Dierctional NAT will be
backward compatable, i.e. it will install private addresses
learned from Uni Directional NAT interfaces in the routing
table of NAT router.If 'disabled' private address will not
be visible in the routing table which is a Multi NAT feature.
For Multi NAT this attribute will be ignored
Parsed from file nat.mib.txt
Company: None
Module: Wellfleet-NAT-MIB
This MIB was added in BayRS 14.20 to address a
compatibility issue concerning non-DNS NAT
translations when upgrading from a pre-14.20
NAT configuration to a 14.20 or greater version
of BayRS software. This MIB should remain enabled.
Disabling this MIB will cause Uni-directional NAT
to no longer function correctly on the router.
Parsed from file Wellfleet-NAT-MIB.mib
Module: Wellfleet-NAT-MIB
Vendor: Wellfleet
Module: Wellfleet-NAT-MIB
[Automatically extracted from oidview.com]
wfNatBaseInstallUniPrivAddr OBJECT-TYPE SYNTAX INTEGER { enabled(1), disabled(2) } ACCESS read-write STATUS mandatory DESCRIPTION "The administrative status of Uni Directional NAT. The value `enabled' denotes that the Uni Dierctional NAT will be backward compatable, i.e. it will install private addresses learned from Uni Directional NAT interfaces in the routing table of NAT router.If 'disabled' private address will not be visible in the routing table which is a Multi NAT feature. For Multi NAT this attribute will be ignored" DEFVAL { enabled } ::= { wfNatBase 19 }
wfNatBaseInstallUniPrivAddr OBJECT-TYPE SYNTAX INTEGER { enabled(1), disabled(2) } ACCESS read-write STATUS mandatory DESCRIPTION "This MIB was added in BayRS 14.20 to address a compatibility issue concerning non-DNS NAT translations when upgrading from a pre-14.20 NAT configuration to a 14.20 or greater version of BayRS software. This MIB should remain enabled. Disabling this MIB will cause Uni-directional NAT to no longer function correctly on the router." DEFVAL { enabled } ::= { wfNatBase 19 }
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.18.3.5.3.2.7.1.19.0 | wfNatBaseInstallUniPrivAddr | 0 | 0 | None |
OID | Name | Sub children | Sub Nodes Total | Description |
---|---|---|---|---|
1.3.6.1.4.1.18.3.5.3.2.7.1.1 | wfNatBaseDelete | 1 | 1 | 'This value determines whether NAT is configured' |
1.3.6.1.4.1.18.3.5.3.2.7.1.2 | wfNatBaseDisable | 1 | 1 | 'The administrative status of NAT in the router. The value 'enabled' denotes that the NAT Process is active on at least one inte… |
1.3.6.1.4.1.18.3.5.3.2.7.1.3 | wfNatBaseState | 1 | 1 | 'The state of NAT' |
1.3.6.1.4.1.18.3.5.3.2.7.1.4 | wfNatBaseSoloistSlotMask | 1 | 1 | Slot mask for which slots the soloist gate is eligible to run on. The MSBit represents slot 1, the next most significant bit rep… |
1.3.6.1.4.1.18.3.5.3.2.7.1.5 | wfNatBaseSoloistSlot | 1 | 1 | Slot on which NAT soloist gate is running. Slots can be 1-14. Default is zero. |
1.3.6.1.4.1.18.3.5.3.2.7.1.6 | wfNatBaseLogMask | 1 | 1 | A parameter to specify which NAT log messages should be logged. Each bit represents a message as defined below. A 1 in that bit … |
1.3.6.1.4.1.18.3.5.3.2.7.1.7 | wfNatBaseMapTimeout | 1 | 1 | This controls whether or not the dynamic mapping table entries are aged out when unused. |
1.3.6.1.4.1.18.3.5.3.2.7.1.8 | wfNatBaseMapMaxTimeout | 1 | 1 | The maximum time in seconds before unused NAT mapping table entries are deleted. This timeout or aging does not apply to static m… |
1.3.6.1.4.1.18.3.5.3.2.7.1.9 | wfNatBaseMapDynMapsCount | 1 | 1 | Number of Dynamic Mappings in the dymanic mapping table |
1.3.6.1.4.1.18.3.5.3.2.7.1.10 | wfNatBaseFtpSessionCount | 1 | 1 | Number of FTP sessions detected on this box translated by NAT |
1.3.6.1.4.1.18.3.5.3.2.7.1.11 | wfNatBaseNto1TrTotCount | 1 | 1 | Total number of active Nto1 translation counts on the box. |
1.3.6.1.4.1.18.3.5.3.2.7.1.12 | wfNatBaseSynchronization | 1 | 1 | The administrative status of NAT Synchronization in the router. The value `enabled' denotes that the NAT Synchronization is activ… |
1.3.6.1.4.1.18.3.5.3.2.7.1.13 | wfNatBaseSynRouterID | 1 | 1 | This represents the Router Identifier for NAT Synchronization Only. This is used to detect the duplicate TCP connection between p… |
1.3.6.1.4.1.18.3.5.3.2.7.1.14 | wfNatBaseSynPort | 1 | 1 | This represents the TCP port on which the connection requests from the peers will be accepted. When NAT Synchronization Protocol … |
1.3.6.1.4.1.18.3.5.3.2.7.1.15 | wfNatBaseSynKeepAlvInterval | 1 | 1 | Idle session timeout period, in seconds. If an established TCP connection remains inactive for this interval, KEEPALIVE messages… |
1.3.6.1.4.1.18.3.5.3.2.7.1.16 | wfNatBaseSynKeepAlvTimer | 1 | 1 | KEEPALIVE retransmit timeout period, in seconds. This is the interval at which unacknowledged KEEPALIVE messages will be retrans… |
1.3.6.1.4.1.18.3.5.3.2.7.1.17 | wfNatBaseSynKeepAlvRetries | 1 | 1 | Number of unacknowledged KEEPALIVE messages retransmitted before the TCP session is terminated. If this count is set to zero, on… |
1.3.6.1.4.1.18.3.5.3.2.7.1.18 | wfNatBaseLocalToLocalEnable | 1 | 1 | Allow forwarding of traffic from one local NAT interface to another local NAT interface. |