The position of the MDC in this stack of units. Note that the top unit
in the stack is unit #1
Parsed from file Compaq-n3612.mib.txt
Company: compaq
Module: COMPAQ-CPQN3612-MIB
fsThisAgent OBJECT-TYPE SYNTAX INTEGER ACCESS read-only STATUS mandatory DESCRIPTION "The position of the MDC in this stack of units. Note that the top unit in the stack is unit #1" ::= { fsModuleInfo 1 }
Child arc 0 is used to translate between SNMPv1 and SNMPv2 notification parameters as explained in IETF RFC 2576, section 3.
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.232.101.1.1.2.1.0 | fsThisAgent | 0 | 0 | None |
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.232.101.1.1.2.2 | fsPreBootMajorVer | 1 | 1 | The major number of the Pre-Boot Flash Block version. For example, if the firmware version is 2.12, the value of this object wou… |
| 1.3.6.1.4.1.232.101.1.1.2.3 | fsPreBootMinorVer | 1 | 1 | The minor number of the Pre-Boot Flash Block version. For example, if the firmware version is 2.12, the value of this object wou… |
| 1.3.6.1.4.1.232.101.1.1.2.4 | fsBootMajorVer | 1 | 1 | The major number of the Boot Block Flash version. For example, if the firmware version is 2.12, the value of this object would b… |
| 1.3.6.1.4.1.232.101.1.1.2.5 | fsBootMinorVer | 1 | 1 | The minor number of the Boot Flash Block version. For example, if the firmware version is 2.12, the value of this object would b… |
| 1.3.6.1.4.1.232.101.1.1.2.6 | fsRuntimeMajorVer | 1 | 1 | The major number of the Runtime Flash Block version. For example, if the firmware version is 2.12, the value of this object woul… |
| 1.3.6.1.4.1.232.101.1.1.2.7 | fsRuntimeMinorVer | 1 | 1 | The minor number of the Runtime Flash Block version. For example, if the firmware version is 2.12, the value of this object woul… |
| 1.3.6.1.4.1.232.101.1.1.2.8 | fsBootWriteCycles | 1 | 1 | This object will allow the user to see the number of erase/writes that have been made to the Boot block on the FLASH PROM chip. |
| 1.3.6.1.4.1.232.101.1.1.2.9 | fsRuntimeWriteCycles | 1 | 1 | This object will allow the user to see the number of erase/writes that have been made to the RunTime block on the FLASH PROM chi… |
| 1.3.6.1.4.1.232.101.1.1.2.10 | fsWriteCommunity | 1 | 1 | The write community name for the Management Agent. If the value is not public, the write community name is not returned for get … |
| 1.3.6.1.4.1.232.101.1.1.2.11 | fsWriteProtect | 1 | 1 | When set to ro(2), all supported MIB objects, with the exception of this object are made read only. This may be used in conjunct… |
| 1.3.6.1.4.1.232.101.1.1.2.12 | fsIPFrameType | 1 | 1 | Except when booting up, a hub will communicate over IP using a single frame type defining the type of network that the IP traffi… |
| 1.3.6.1.4.1.232.101.1.1.2.13 | fsIPXFrameType | 1 | 1 | The frame type over which IPX communication originating from the compaq3612 will take place. The unit will respond to a packet u… |
| 1.3.6.1.4.1.232.101.1.1.2.14 | fsIPXSAPBroadcast | 1 | 1 | The hub will generate SAP broadcasts over IPX. This allows the hub to be auto-discovered by Novell's NMS and is used to generat… |
| 1.3.6.1.4.1.232.101.1.1.2.15 | fsIPAutoDiscoveryState | 1 | 1 | This object will allow a user to enable the unit to send out periodic ICMP Pings to ensure that the unit's IP Address is contain… |
| 1.3.6.1.4.1.232.101.1.1.2.16 | fsPingPacketRate | 1 | 1 | This object will determine the rate (in seconds) at which ICMP Pings will be sent out by the unit to ensure that its IP Address … |
| 1.3.6.1.4.1.232.101.1.1.2.17 | fsBootpRarpRetries | 1 | 1 | This object will allow the user to set the number of BOOTP/RARP retries that will be performed when the unit goes through its Bo… |
| 1.3.6.1.4.1.232.101.1.1.2.18 | fsBootpRarpRetryInterval | 1 | 1 | This object will allow the user to set the time period (in seconds) after which a BOOTP/RARP attempt will time out and the unit … |
| 1.3.6.1.4.1.232.101.1.1.2.19 | fsBootpRarpRequests | 1 | 1 | This object allows the user to enable/disable generation of BOOTP/RARP requests from the Hub in BOTH Boot and RunTime code. In B… |
| 1.3.6.1.4.1.232.101.1.1.2.20 | fsVT100ScreenRefresh | 1 | 1 | This object will determine the rate, in seconds, at which the VT100 screen will refresh (i.e, update) the automatic fields (e.g.… |
| 1.3.6.1.4.1.232.101.1.1.2.21 | fsRptrReset | 1 | 1 | Setting this object to reset(2) causes the unit to reset the management agent but retains the counter values. All non-durable in… |
| 1.3.6.1.4.1.232.101.1.1.2.22 | fsModemInitString | 1 | 1 | This object provides a Modem Initialization String input which will be used to initialize a modem to the proper configuration. T… |
| 1.3.6.1.4.1.232.101.1.1.2.23 | fsModemAutoNegotiateState | 1 | 1 | If enabled(1), then the compaq3612 will adjust its speed to that specified when the modem answers the incoming connection. If th… |