The frame type over which IPX communication originating from the compaq3612
will take place. The unit will respond to a packet using the same frame
type as was used in the request. This frame type comes into effect on any
packet that is generated by the MDC, not in response to another external
packet. An example is a Trap. DURABLE
Parsed from file Compaq-n3612.mib.txt
Company: compaq
Module: COMPAQ-CPQN3612-MIB
fsIPXFrameType OBJECT-TYPE SYNTAX INTEGER { ethernet-ii(1), ethernet-802-3-raw(2), ieee-802-2(3), ieee-802-2-snap(4) } ACCESS read-write STATUS mandatory DESCRIPTION "The frame type over which IPX communication originating from the compaq3612 will take place. The unit will respond to a packet using the same frame type as was used in the request. This frame type comes into effect on any packet that is generated by the MDC, not in response to another external packet. An example is a Trap. DURABLE" ::= { fsModuleInfo 13 }
Child arc 0 is used to translate between SNMPv1 and SNMPv2 notification parameters as explained in IETF RFC 2576, section 3.
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.232.101.1.1.2.13.0 | fsIPXFrameType | 0 | 0 | None |
| OID | Name | Sub children | Sub Nodes Total | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.232.101.1.1.2.1 | fsThisAgent | 1 | 1 | The position of the MDC in this stack of units. Note that the top unit in the stack is unit #1 |
| 1.3.6.1.4.1.232.101.1.1.2.2 | fsPreBootMajorVer | 1 | 1 | The major number of the Pre-Boot Flash Block version. For example, if the firmware version is 2.12, the value of this object wou… |
| 1.3.6.1.4.1.232.101.1.1.2.3 | fsPreBootMinorVer | 1 | 1 | The minor number of the Pre-Boot Flash Block version. For example, if the firmware version is 2.12, the value of this object wou… |
| 1.3.6.1.4.1.232.101.1.1.2.4 | fsBootMajorVer | 1 | 1 | The major number of the Boot Block Flash version. For example, if the firmware version is 2.12, the value of this object would b… |
| 1.3.6.1.4.1.232.101.1.1.2.5 | fsBootMinorVer | 1 | 1 | The minor number of the Boot Flash Block version. For example, if the firmware version is 2.12, the value of this object would b… |
| 1.3.6.1.4.1.232.101.1.1.2.6 | fsRuntimeMajorVer | 1 | 1 | The major number of the Runtime Flash Block version. For example, if the firmware version is 2.12, the value of this object woul… |
| 1.3.6.1.4.1.232.101.1.1.2.7 | fsRuntimeMinorVer | 1 | 1 | The minor number of the Runtime Flash Block version. For example, if the firmware version is 2.12, the value of this object woul… |
| 1.3.6.1.4.1.232.101.1.1.2.8 | fsBootWriteCycles | 1 | 1 | This object will allow the user to see the number of erase/writes that have been made to the Boot block on the FLASH PROM chip. |
| 1.3.6.1.4.1.232.101.1.1.2.9 | fsRuntimeWriteCycles | 1 | 1 | This object will allow the user to see the number of erase/writes that have been made to the RunTime block on the FLASH PROM chi… |
| 1.3.6.1.4.1.232.101.1.1.2.10 | fsWriteCommunity | 1 | 1 | The write community name for the Management Agent. If the value is not public, the write community name is not returned for get … |
| 1.3.6.1.4.1.232.101.1.1.2.11 | fsWriteProtect | 1 | 1 | When set to ro(2), all supported MIB objects, with the exception of this object are made read only. This may be used in conjunct… |
| 1.3.6.1.4.1.232.101.1.1.2.12 | fsIPFrameType | 1 | 1 | Except when booting up, a hub will communicate over IP using a single frame type defining the type of network that the IP traffi… |
| 1.3.6.1.4.1.232.101.1.1.2.14 | fsIPXSAPBroadcast | 1 | 1 | The hub will generate SAP broadcasts over IPX. This allows the hub to be auto-discovered by Novell's NMS and is used to generat… |
| 1.3.6.1.4.1.232.101.1.1.2.15 | fsIPAutoDiscoveryState | 1 | 1 | This object will allow a user to enable the unit to send out periodic ICMP Pings to ensure that the unit's IP Address is contain… |
| 1.3.6.1.4.1.232.101.1.1.2.16 | fsPingPacketRate | 1 | 1 | This object will determine the rate (in seconds) at which ICMP Pings will be sent out by the unit to ensure that its IP Address … |
| 1.3.6.1.4.1.232.101.1.1.2.17 | fsBootpRarpRetries | 1 | 1 | This object will allow the user to set the number of BOOTP/RARP retries that will be performed when the unit goes through its Bo… |
| 1.3.6.1.4.1.232.101.1.1.2.18 | fsBootpRarpRetryInterval | 1 | 1 | This object will allow the user to set the time period (in seconds) after which a BOOTP/RARP attempt will time out and the unit … |
| 1.3.6.1.4.1.232.101.1.1.2.19 | fsBootpRarpRequests | 1 | 1 | This object allows the user to enable/disable generation of BOOTP/RARP requests from the Hub in BOTH Boot and RunTime code. In B… |
| 1.3.6.1.4.1.232.101.1.1.2.20 | fsVT100ScreenRefresh | 1 | 1 | This object will determine the rate, in seconds, at which the VT100 screen will refresh (i.e, update) the automatic fields (e.g.… |
| 1.3.6.1.4.1.232.101.1.1.2.21 | fsRptrReset | 1 | 1 | Setting this object to reset(2) causes the unit to reset the management agent but retains the counter values. All non-durable in… |
| 1.3.6.1.4.1.232.101.1.1.2.22 | fsModemInitString | 1 | 1 | This object provides a Modem Initialization String input which will be used to initialize a modem to the proper configuration. T… |
| 1.3.6.1.4.1.232.101.1.1.2.23 | fsModemAutoNegotiateState | 1 | 1 | If enabled(1), then the compaq3612 will adjust its speed to that specified when the modem answers the incoming connection. If th… |